There are several types of life test method for hose assemblies. The two major tests used for hose assemblies are impulse test and burst test. And magnification adjustment of impulse pressure, heating of testing oil and repetitive motions of bending and straightening of testing hose are also performed for accelerating the life. According to the manufacture process of hose and swaging process of fitting, there is a difference in the life of hose assemblies from minimum 7 times to maximum 40 times during the life test in the same functioning condition. Like this, the life test of hose which has a wide scope of life distribution gives a problem that observation should take a long time to find out the existence of the bursting from the beginning of the test to the completion of bursting of hose assemblies. Therefore, this research proposes a process of concentrating on the defective section of hose assemblies and maximizing the life acceleration by giving ‘Knockdown stress’ to hose assemblies just until before the hose assemblies get out of order.

The safety factor of hydraulic piston pumps and motors shows a tendency to decrease due to high pressurization, high speed and low weight/volume realization to enhance the output density. Therefore, more effective test models are necessary to predict the exact life. The sensitive parameters in the endurance life test are speed, pressure and temperature, and failure production increases in proportion to the operating time. In this research, the authors propose a combined accelerated life test model using the analysis method of the combined accelerated life test results of piston-shoe assemblies by simultaneously applying high speed, high pressure and high temperature in accordance with the variation in speed, pressure and temperature in order to reduce the life test time.

Friction welding of dissimilar materials, Ni-base superalloy IN713LC and oil-quench plus tempered AISI 4140 steel, was investigated. Friction welding was carried out with various process variables such as friction pressure and time. The quality of welded joints was tested by applying bending stresses in an appropriate jig. Microstructures of the heat-affected zone (HAZ) were investigated along with micro-hardness tests over the friction weld joints. DEFORM-2D FE code was used to simulate the effect of welding variables in friction welding process on the distributions of the state variables such as strain, strain rate and temperature. The formation of the metal burr during the friction welding process was successfully simulated, and the temperature distribution in the heat-affected zone indicated a good agreement with the variation of the microstructures in the HAZ.

No abstract

No abstract