In this paper, we characterize the leaching of heavy metals (Ni, Cu, Zn, Cd, and Pb) from eight contaminated soils over a wide range of pH (pH 0.4-12) using an original approach based on batch pH-static leaching experiments in combination with selective chemical extractions and geochemical modeling. The leached concentrations of the heavy metals are generally much lower than the total concentrations and show a strong pH dependency, resulting in "V-shaped" leaching curves with orders of magnitude changes in solution concentrations. The "multisurface" model used incorporates adsorption to dissolved and solid organic matter (NICA-Donnan), iron/aluminum (hydr)oxide (generalized two-layer model) and clay (Donnan model). These models were applied without modifications, and only the standard set of binding constants and parameters was used (i.e., without any fitting). The model predictions of heavy metal leaching are generally adequate and sometimes excellent. Results from speciation calculations are consistent with the well-recognized importance of organic matter as the dominant reactive solid phase in soils. The observed differences between soils with respect to element speciation in the solid phase correspond to the relative amounts of the reactive surfaces present in the soils. In the solution phase, complexes with dissolved organic matter (DOM) are predominant over most of the pH range. Free metal ions (Me2+) are generally the dominant species below pH 4. The combination of the experimental and modeling approach as used in this study is shown to be promising because it leads to a more fundamental understanding of the pH-dependent leaching processes in soils. The "multisurface" modeling approach, with the selected sorption models, is shown to be able to adequately predict the leaching of heavy metals from contaminated soils over a wide range of conditions, without any fitting of parameters.

No abstract

The performance of a multisurface sorption model approach, composed of well-accepted surface complexation models in combination with published "generic" parameter sets, is evaluated for its possible use in risk assessment. For that purpose, the leaching of a broad range of potential soil contaminants (Ni, Cu, Zn, Cd, Pb, Ba, Cr, Co, Mo, V, Sn, Sb, S, As, Se) from eight diffusely and industrially contaminated soils is predicted simultaneously without any parameter optimization. The model approach includes aqueous speciation in combination with sorption to organic matter (NICA-Donnan model), Fe/Al(hydr)oxides (Generalized Two-Layer Model), and clay (Donnan model). Independent data generated by pH-static leaching experiments, performed with individual subsamples over a wide pH range (pH 0.4-12), provide a sensitive evaluation of the model performance. Root-mean-squared error values between predicted and measured log concentrations over the entire pH range, RMSE(log), are < 0.5 for Cu, Ni, Cd, Co, S, and Se, and RMSE(log) < 1 for Zn, Ba, Cr, Pb, Sn, Mo, Sn and As. The approach without parameter optimization has led to recommendations for further research with particular emphasis on identification of leaching mechanisms for Pb, Mo, Sb, and V and further expansion of the data sets to reduce the uncertainty of the available generic sorption parameters for Sn, Sb, Ba, Cr, and V.

This paper provides an improved understanding of the leaching behavior of waste incineration air-pollution-control (APC) residues in a long-term perspective. Leaching was investigated by a series of batch experiments reflecting leaching conditions after initial washout of highly soluble salts from residues. Leaching experiments were performed at a range of pH-values using carbonated and noncarbonated versions of two APC residues. The leaching data were evaluated by geochemical speciation modeling and discussed with respect to possible solubility control. The leaching of major elements as well as trace elements was generally found to be strongly dependent on pH. As leaching characterization was performed in the absence of high salt levels, the presented results represent long-term leaching after initial washout from a disposal site, that is, liquid-to-solid ratios above 1-2 L/kg. The leaching of Al, Ba, Ca, Cr, Pb, S, Si, V, and Zn was found influenced by solubility control from A12O3, Al(OH)3, Ba(S,Cr)04 solid solutions, BaSO4, Ca6Al2(SO4)3(OH)12 x 26H2O, CaAl2Si4O12 x 2H2O, Ca(OH)2, CaSiO3, CaSO4 x 2H2O, CaZn2(OH)6 x 2H2O, KAlSi2O6, PbCO3, PbCrO4, Pb2O3, Pb2V2O7, Pb3(VO4)2, ZnO, Zn2SiO4, and ZnSiO3. The presented dataset and modeling results form a thorough contribution to the assessment of long-term leaching behavior of APC residues under a wide range of conditions.