Abstract. Total column ozone reduction in the Arctic is evaluated each winter since 1993/1994 by the transport method (3-D CTM passive ozone minus measurements). The cumulative loss from 1 December to the end of the season ranges from 5–10% during warm winters like 1998/1999, 2000/2001 and 2001/2002 up to 30%–32% during cold winters like 1994/1995 and 1995/1996. The 23% cumulative loss observed during the winter 2002/2003 is similar in amplitude to the 20–24% measured in 1996/1997 and 1999/2000 but the timing is different. It started unusually early in December after the occurrence of very low temperature at all stratospheric levels between 550 K and 435 K allowing PSC formation and thus chlorine activation. The early ozone loss of 2002/2003 is well captured by current 3-D CTM models.

Abstract. For the first time, results of all four existing stratospheric BrO profiling instruments, are presented and compared with reference to the SLIMCAT 3-dimensional chemical transport model (3-D CTM). Model calculations are used to infer a BrO profile validation set, measured by 3 different balloon sensors, for the new Envisat/SCIAMACHY (ENVIronment SATellite/SCanning Imaging Absorption spectroMeter for Atmospheric CHartographY) satellite instrument. The balloon observations include (a) balloon-borne in situ resonance fluorescence detection of BrO, (b) balloon-borne solar occultation DOAS measurements (Differential Optical Absorption Spectroscopy) of BrO in the UV, and (c) BrO profiling from the solar occultation SAOZ (Systeme d'Analyse par Observation Zenithale) balloon instrument. Since stratospheric BrO is subject to considerable diurnal variation and none of the measurements are performed close enough in time and space for a direct comparison, all balloon observations are considered with reference to outputs from the 3-D CTM. The referencing is performed by forward and backward air mass trajectory calculations to match the balloon with the satellite observations. The diurnal variation of BrO is considered by 1-D photochemical model calculation along the trajectories. The 1-D photochemical model is initialised with output data of the 3-D model with additional constraints on the vertical transport, the total amount and photochemistry of stratospheric bromine as given by the various balloon observations. Total [Bry]=(20.1±2.8)pptv obtained from DOAS BrO observations at mid-latitudes in 2003, serves as an upper limit of the comparison. Most of the balloon observations agree with the photochemical model predictions within their given error estimates. First retrieval exercises of BrO limb profiling from the SCIAMACHY satellite instrument agree to <±50% with the photochemically-corrected balloon observations, and tend to show less agreement below 20 km.