The objective of this study was to establish such operating conditions in a sequencing batch reactor (SBR) that will enable the achievement of the highest possible share of denitrifying P removal in nutrient elimination. Two different operating strategies for SBRs were analysed. Both of these strategies used a forced anoxic phase in the SBR treatment cycle. The first one was based on an intermittent aeration, which led to periodic occurrence of anoxic conditions when the uptake of P-PO4(3-) could occur. The second strategy was based on mimicking the A2O process and forcing an anoxic phase straight after an anaerobic phase. The experiments were performed in a laboratory reactor operating at a maximum fill of 26.8-27.7 litres and a constant temperature of 18 degrees C. It was found that a SBR configuration with intermittent aeration did not allow the achievement of significant denitrifying P removal, despite the DPAO/PAO ratio being equal to 50.5%. Almost the entire load of orthophosphates was being removed in aerobic conditions right after the anaerobic phase, even though this aerobic period lasted only 20 minutes. However, a SBR with a forced anoxic phase occurring after an anaerobic phase and created by an introduction of NO(x) rich stream of wastewater guaranteed the highest DPAO/PAO ratio of 82.8% and the highest share of denitrifying P removal (above 80%) in the total removal of phosphorus.

The objective of this study is to compare wastewater treatment effectiveness in sequencing batch reactor (SBR) and integrated fixed-film activated sludge-moving-bed sequencing batch biofilm reactor (IFAS-MBSBBR) systems in specific technological conditions. The comparison of these two technologies was based on the following assumptions, shared by both series, I and II: the reactor's active volume was 28 L; 8-hour cycle of reactor's work, with the same sequence and duration of its consecutive phases; and the dissolved oxygen concentration in the aerobic phases was maintained at a level of 3.0 mg O2/L. For both experimental series (I and II), comparable effectiveness of organic compound (chemical oxygen demand (COD)) removal, nitrification and biological phosphorus removal has been obtained at levels of 95.1%, 97% and 99%, respectively. The presence of the carrier improved the efficiency of total nitrogen removal from 86.3% to 91.7%. On the basis of monitoring tests, it has been found that the ratio of simultaneous denitrification in phases with aeration to the total efficiency of denitrification in the cycle was 1.5 times higher for IFAS-MBSBBR.

This article presents the results of research into the influence of one, two and three wastewater feedings in a cycle on efficiency and performance of combined biological nitrogen and phosphorus removal in an integrated fixed-film activated sludge and moving-bed sequencing batch biofilm reactor (IFAS-MBSBBR). The experiment lasted 158 days and was conducted in two laboratory models of the IFAS-MBSBBR with an active volume of 28 L. It was found that along with an increase in the number of wastewater feedings, an increase in nitrogen removal efficiency was observed (from 56.9 ± 2.30% for a single feeding to 91.4 ± 1.77% for three feedings). Moreover, the contribution of simultaneous nitrification/denitrification in nitrogen removal increased (from 2.58% for a single feeding to 69.5% for three feedings). Systems with a greater number of feedings stimulated the process of denitrifying phosphorus removal. Regardless of the way in which wastewater feeding was applied to the IFAS-MBSBBR, highly efficient chemical oxygen demand (COD) removal (94.8 ± 1.80%) and biological phosphorus removal (98.9 ± 0.87%) were achieved.

No abstract

Abstract. The main goal of the study was to evaluate the effects of mechanical sludge disintegration for enhancing full scale anaerobic digestion of municipal sludge. Batch disintegration tests and lab dewatering tests were also performed aiming at determining the release of organic compounds and assessing the impact of disintegration of excess sludge before the fermentation process of mixed sludge on the dewaterability of post-fermented sludge, respectively. In the study a disc disintegrator driven by a motor with a power of 30 kW, revolutions n = 2950 rpm has been used. It was shown that with increase of energy consumed in the disintegration, the increased amounts of organic compounds were released from the sludge. It was also documented that the introduction of the excess sludge disintegration prior to fermentation tank, resulted in a significant increase in biogas production (by an average of 33.9%) and in increase in volatile total solids reduction in the fermented sludge (by an average of 22.7%). Moreover, the obtained results indicate the possibility of obtaining a higher degree of sludge dewatering, which was subjected to anaerobic stabilization with using disintegrated excess sludge.