Nitrogen-doped carbon nanotubes are selective and robust electrocatalysts for CO2 reduction to formate in aqueous media without the use of a metal catalyst. Polyethylenimine (PEI) functions as a co-catalyst by significantly reducing catalytic overpotential and increasing current density and efficiency. The co-catalysis appears to help in stabilizing the singly reduced intermediate CO2(•-) and concentrating CO2 in the PEI overlayer.

No abstract

Photoelectrochemical (PEC) water splitting and solar fuels hold great promise for harvesting solar energy. TiO2-based photoelectrodes for water splitting have been intensively investigated since 1972. However, solar-to-fuel conversion efficiencies of TiO2 photoelectrodes are still far lower than theoretical values. This is partially due to the dilemma of a short minority carrier diffusion length, and long optical penetration depth, as well as inefficient electron collection. We report here the synthesis of TiO2 PEC electrodes by coating solution-processed antimony-doped tin oxide nanoparticle films (nanoATO) on FTO glass with TiO2 through atomic layer deposition. The conductive, porous nanoATO film-supported TiO2 electrodes, yielded a highest photocurrent density of 0.58 mA/cm(2) under AM 1.5G simulated sunlight of 100 mW/cm(2). This is approximately 3× the maximum photocurrent density of planar TiO2 PEC electrodes on FTO glass. The enhancement is ascribed to the conductive interconnected porous nanoATO film, which decouples the dimensions for light absorption and charge carrier diffusion while maintaining efficient electron collection. Transient photocurrent measurements showed that nanoATO films reduce charge recombination by accelerating transport of photoelectrons through the less defined conductive porous nanoATO network. Owing to the large band gap, scalable solution processed porous nanoATO films are promising as a framework to replace other conductive scaffolds for PEC electrodes.

Textured diamond films have been deposited on β-SiC via microwave plasma chemical vapor deposition preceded by an in situ bias pretreatment that enhances nucleation. Approximately 50% of the initial diamond nuclei appear to be aligned with the C(001) planes parallel to the SiC(001), and C[110] directions parallel to the SiC[110] within 3°. The diamond was characterized by Raman spectroscopy and scanning electron microscopy.

Ordered diamond films have been deposited on single-crystal silicon substrates via an in situ carburization followed by bias-enhanced nucleation. Textured diamond films with greater than 50% of the grains oriented D(100)//Si(100) and D〈110〉//Si〈110〉 were grown in both a horizontal and vertical microwave plasma chemical vapor deposition reactor. Separate diamond films from each of the two reactors were analyzed both by scanning electron microscopy and Raman spectroscopy. The in situ carburization is speculated to form an epitaxial SiC conversion layer, thus providing an economical alternative to obtaining epitaxial diamond films on single-crystal SiC.