Asbestos-free friction composite based on ultrafine full-vulcanized acrylonitrile butadiene rubber particles (UFNBRPs)-modified polybenzoxazine was successfully developed. The UFNBRPs-modified polybenzoxazine friction composite was characterized for chemical, tribological, and mechanical properties as well as thermal stability. The UFNBRPs not only act as a filler to reduce noise in the friction composites due to their suitable viscoelastic behaviors but also play a key role in friction modifiers to enhance friction coefficient and wear resistance in the polybenzoxazine composites. The chemical bonding formation between UFNBRPs and polybenzoxazine can significantly improve friction, mechanical, and thermal properties of the friction composite. The outstanding tribological performance of the friction composite under 100–350 °C, i.e., friction coefficients and wear rates in a range of 0.36–0.43 and 0.13 × 10−4–0.29 × 10−4 mm3/Nm, respectively, was achieved. The high flexural strength and modulus of the friction composite, i.e., 61 MPa and 6.4 GPa, respectively, were obtained. The friction composite also showed high thermal stability, such as 410 °C for degradation temperature and 215 °C for glass transition temperature. The results indicated that the obtained UFNBRPs-modified polybenzoxazine friction composite meets the industrial standard of brake linings and pads for automobiles; therefore, the UFNBRPs-modified polybenzoxazine friction composite can effectively be used as a replacement for asbestos-based friction materials.

Frictional composites based on polybenzoxazine (PBA-a) and acrylonitrile-butadiene rubber (NBR) are developed in this study. Mechanical, thermal and tribological properties of the PBA-a/NBR composites at 0, 2, 5, 10 and 15wt% of NBR particle contents are evaluated. Curing behaviors of the NBR-benzoxazine molding compounds are examined by differential scanning calorimetry to show an exothermic peak of about 222°C compared with that of the benzoxazine resin, i.e. 232°C suggesting curing acceleration of the benzoxazine resin due to the presence of the NBR particles. The storage modulus of the NBR-filled PBA-a is observed to systematically decrease from 5.2 GPa of the neat PBA-a to 2.8 GPa with an addition of 15wt% of the rubber particles. Glass transition temperature (Tg) of the composites evaluated by dynamic mechanical analysis increases with increasing of NBR particle contents, i.e. from 172°C for PBA-a to 186°C for PBA-a/15wt% NBR. Furthermore, the friction coefficients of the composites with 2wt% NBR are determined to be 0.603 for static type and 0.528 for kinetic type. Those values are improved from the value of 0.597 and 0.475 for unmodified polybenzoxazine, respectively. Therefore, the obtained outstanding properties, i.e. storage modulus, glass transition temperature and friction coefficient make the polybenzoxazine composites highly attractive to be utilized as friction materials.