When wind speeds are 2–10 m s −1 , reflective contrasts in the ocean surface make oil slicks visible to synthetic aperture radar (SAR) under all sky conditions. Neural network analysis of satellite SAR images quantified the magnitude and distribution of surface oil in the Gulf of Mexico from persistent, natural seeps and from the Deepwater Horizon (DWH) discharge. This analysis identified 914 natural oil seep zones across the entire Gulf of Mexico in pre‐2010 data. Their ∼0.1 µm slicks covered an aggregated average of 775 km 2 . Assuming an average volume of 77.5 m 3 over an 8–24 h lifespan per oil slick, the floating oil indicates a surface flux of 2.5–9.4 × 10 4 m 3 yr −1 . Oil from natural slicks was regionally concentrated: 68%, 25%, 7%, and <1% of the total was observed in the NW, SW, NE, and SE Gulf, respectively. This reflects differences in basin history and hydrocarbon generation. SAR images from 2010 showed that the 87 day DWH discharge produced a surface‐oil footprint fundamentally different from background seepage, with an average ocean area of 11,200 km 2 (SD 5028) and a volume of 22,600 m 3 (SD 5411). Peak magnitudes of oil were detected during equivalent, ∼14 day intervals around 23 May and 18 June, when wind speeds remained <5 m s −1 . Over this interval, aggregated volume of floating oil decreased by 21%; area covered increased by 49% ( p < 0.1), potentially altering its ecological impact. The most likely causes were increased applications of dispersant and surface burning operations.

During any marine oil spill, floating oil slicks that reach shorelines threaten a wide array of coastal habitats. To assess the presence of oil near shorelines during the Deepwater Horizon (DWH) oil spill, we scanned the library of Synthetic Aperture Radar (SAR) imagery collected during the event to determine which images intersected shorelines and appeared to contain oil. In total, 715 SAR images taken during the DWH spill were analyzed and processed, with 188 of the images clearly showing oil. Of these, 156 SAR images showed oil within 10 km of the shoreline with appropriate weather conditions for the detection of oil on SAR data. We found detectable oil in SAR images within 10 km of the shoreline from west Louisiana to west Florida, including near beaches, marshes, and islands. The high number of SAR images collected in Barataria Bay, Louisiana in 2010 allowed for the creation of a nearshore oiling persistence map. This analysis shows that, in some areas inside Barataria Bay, floating oil was detected on as many as 29 different days in 2010. The nearshore areas with persistent floating oil corresponded well with areas where ground survey crews discovered heavy shoreline oiling. We conclude that satellite-based SAR imagery can detect oil slicks near shorelines, even in sheltered areas. These data can help assess potential shoreline oil exposure without requiring boats or aircraft. This method can be particularly helpful when shoreline assessment crews are hampered by difficult access or, in the case of DWH, a particularly large spatial and temporal spill extent.

No abstract

The Deepwater Horizon (DWH) oil blowout in the Gulf of Mexico (GoM) led to the largest offshore oil spill in U.S. history. The accident resulted in oil slicks that covered between 10,000 and upward of 40;000 km 2 of the Gulf between April and July 2010. Quantifying the actual spatial extent of oil over such synoptic scales on an operational basis and, in particular, estimating the oil volume (or slick thickness) of large oil slicks on the ocean surface has proven to be a challenge to researchers and responders alike. This challenge must be addressed to assess and understand impacts on marine and coastal resources and to prepare a response to future spills. We estimated surface oil volume and probability of occurrence of different oil thicknesses during the DWH blowout in the GoM by combining synoptic measurements (2330-km swath) from the satellite-borne NASA Moderate Resolution Imaging Spectroradiometer (MODIS) and nearconcurrent, much narrower swath (∼5 km) hyperspectral observations from the NASA Airborne Visible/Infrared Imaging Spectrometer (AVIRIS). A histogram-matching approach was used to transfer AVIRIS-derived oil volume to MODIS pixel-scale dimensions, after masking clouds under both sun glint and nonglint conditions. Probability functions were used to apply the transformation to 19 MODIS images collected during the DWH event. This generated three types of MODIS oil maps: maps of surface oil volume, maps of relative oil thickness with four different classes (i.e., 0 μm, <0.08 μm, 0.08 to 8 μm, and >8 μm), and maps of probability distributions of different thicknesses. The results were compared with satellite-based synthetic aperture radar measurements and evaluated with concurrent aerial photographs. Although the methods may not be ideal and the results may contain large uncertainties, the current attempt suggests that coarseresolution optical remote sensing observations can provide estimates of relative oil thickness/volume for large oil slicks captured by satellites. © The Authors. Published by SPIE under a Creative Commons Attribution 3.0 Unported License. Distribution or reproduction of this work in whole or in part requires full attribution of the original publication, including its DOI.

No abstract