Miniaturization and manipulation of materials at nanometer scale are key challenges in nanoscience and nanotechnology. In membrane science and technology, the fabrication of ultra-thin polymer films (defect-free) on square meter scale with uniform thickness (<100 nm) is crucial. By using a tailor-made polymer and by controlling the nanofabrication conditions, we developed and manufactured defect-free ultra-thin film membranes with unmatched carbon dioxide permeances, i.e. > 5 m(3) (STP) m(-2) h(-1) bar(-1). The permeances are extremely high, because the membranes are made from a CO(2) philic polymer material and they are only a few tens of nanometers thin. Thus, these thin film membranes have potential application in the treatment of large gas streams under low pressure like, e.g., carbon dioxide separation from flue gas.

Hydroxyl functionalized multi-walled carbon nanotubes (MWCNTs) were blended with Polyacrylonitrile (PAN) to prepare ultrafiltration membranes by a phase inversion process. Three different concentrations of MWCNTs were used in PAN, i.e. 0.5, 1 and 2 wt%. The water flux of the membranes increased by 63% at 0.5 wt% loading of MWCNTs compared to neat PAN membranes. The water flux decreased upon further increase in the concentration of MWCNTs, but at 2 wt% loading it was still higher compared to pure PAN membranes. The surface hydrophilicity of the membranes was enhanced upon the addition of MWCNTs, as observed by contact angle measurements. The increased hydrophilicity might have an impact on the improved water flux. All the membranes showed a molecular weight cut off (MWCO) of approximately 50 Kg/mol. Surface pore size analysis by scanning electron microscopy (SEM) showed no significant difference in the mean pore size of the nanocomposite membranes compared to the neat membranes. The cross section morphology was influenced by the introduction of MWCNTs where less but enlarged macrovoids were observed, particularly prominent at a loading of 2 wt% MWCNTs. The membranes containing 2wt% MWCNTs showed 36% improvement in resistance against compaction compared to neat membranes. Furthermore, the tensile strength of the membranes at 2wt% MWCNTs loading increased over 97% compared to neat ones.

Gas permeation is increasingly considered for high capacity applications. This contribution discusses the commonly employed membrane module types for flat sheet membranes and suggests a new module concept. The applications considered are the separation of CO 2 from flue gas and hydrocarbon dewpointing of natural gas. Rigorous models for predicting the operating performance of the module types are described. Pilot plant experiments were conducted to validate the model for envelope type modules. Simulation studies were carried out to predict the performances of the different module types for the two examples and assess their advantages and disadvantages.

No abstract

Gas permeation characteristics of carbon nanomembranes (CNMs) from self-assembled monolayers are reported for the first time. The assembly of CNMs onto polydimethylsiloxane (PDMS) support membranes allows mechanical measurements under compression as well as determination of gas permeation characteristics. The results suggest that molecular-sized channels in CNMs dominate the permeation properties of the 1 nm thin CNMs.