Towards the EU emissions targets of 2050: Optimal energy renovation measures of Finnish apartment buildings Member countries of the European Union have released targets to reduce carbon dioxide emissions by 80% by the year 2050. Energy use in buildings is a major source of these emissions, which is why this study focused on the cost-optimal renovation of Finnish apartment buildings. Apartment buildings from four

To mitigate the effects of climate change, the European Union calls for major carbon emission reductions in the building sector through a deep renovation of the existing building stock. This study examines the cost-effective energy retrofit measures in Finnish detached houses. The Finnish detached house building stock was divided into four age classes according to the building code in effect at the time of their construction. Multi-objective optimization with a genetic algorithm was used to minimize the life cycle cost and CO2 emissions in each building type for five different main heating systems (district heating, wood/oil boiler, direct electric heating, and ground-source heat pump) by improving the building envelope and systems. Cost-effective emission reductions were possible with all heating systems, but especially with ground-source heat pumps. Replacing oil boilers with ground-source heat pumps (GSHPs), emissions could be reduced by 79% to 92% across all the studied detached houses and investment levels. With all the other heating systems, emission reductions of 20% to 75% were possible. The most cost-effective individual renovation measures were the installation of air-to-air heat pumps for auxiliary heating and improving the thermal insulation of external walls.

This paper proposes various community-sized solar heating systems configurations for cold climate. Three configurations were proposed, (I)a heat pump connected to two tanks in parallel, using charged borehole storage, (II)a heat pump connected between two tanks, using charged borehole storage to directly charge the lower temperature tank, and (III)two heat pumps used in series, one between the tanks and the other between the lower temperature tank and ground. In configurations (I) and (II) the vertical borehole field is used as a seasonal storage, in (III) it is used to extract heat only. The studied energy flows are heat and electricity. The border consists of energy production systems, heating grid and buildings. The impact of the considered system solutions on the heating renewable energy fraction, on-site electrical energy fraction, purchased energy and full cost as a function of the demand, solar thermal and photovoltaic areas, tanks and borehole volumes has been evaluated. The dynamic simulations results shows that an average renewable energy fraction of 53-81% can be achieved, depending upon the energy systems' configuration. Furthermore, Energy System II utilizes less energy compared to other systems. In all three systems medium-sized solar thermal area is more beneficial instead of large area.

Solar thermal energy is widely recognized as one of the most important renewable energy resources. However, in high latitudes, due to various climatic and mismatch challenges, such solar district heating networks are difficult to implement. The objective of the paper is to optimize and compare two different design layouts and control strategies for solar district heating systems in Finnish conditions. The two different designs proposed are a centralized and a semidecentralized solar district heating system. The centralized system consists of two centralized short-term tanks operating at different temperature levels charged by a solar collector and heat pumps. Borehole thermal energy storage is also charged via these two centralized tanks. In contrast, the semi-decentralized system consists of one centralized low temperature tank charged by a solar collector and a borehole thermal energy storage and decentralized high temperature tank charged by an individual heat pump in each house. In this case, borehole thermal energy storage is charged only by the centralized warm tank. These systems are designed using the dynamic simulation software TRNSYS for Finnish conditions. Later on, multi-objective optimization is carried out with a genetic algorithm using the MOBO (Multiobjective building optimizer) optimization tool, where two objectives, i.e. purchased electricity and life cycle costs, are minimized. Various design variables are considered, which included both component sizes and control parameters as inputs to the optimization. The optimization results show that in terms of life cycle cost and purchased electricity, the decentralized system clearly outperforms the centralized system. With a similar energy performance, the reduction in life cycle cost is up to 35% for the decentralized system. Both systems can achieve close to 90% renewable energy fraction. These systems are also sensitive to the prices. Furthermore, the results show that the solar thermal collector area and seasonal storage volume can be reduced in a decentralized system to reduce the cost compared to a centralized system. The losses in the centralized system are 40 -12% higher compared to the decentralized system. The results also show that in both systems, high performance is achieved when the borehole storage is wider with less depth, as it allows better direct utilization of seasonally stored heat. The system layout and controls varied the performance and life cycle cost; therefore it is essential to consider these when implementing such systems.

There is a substantial need to accelerate the advancement and implementation of clean energy technologies in order to solve the challenges of the energy crisis and climate change. Solar heating technology is a feasible solution among clean energy technologies. In real conditions such complex systems often suffer from different kinds of technical failures and deviations reducing the system performance. This paper focuses on the challenges of a solar district heating system at high latitudes, proposes an optimized solution and investigates the influence of possible failures in planning, implementation and operation phase. The configuration proposed is a heat pump connected between two tanks, using solar-charged borehole storage to directly charge the lower temperature tank. Dynamic simulations were performed and a multi-objective optimization was carried out. The impact of the considered system solutions on the renewable energy fraction, purchased electricity and investment cost as a function of demand, solar thermal and photovoltaic areas, tanks and borehole volumes have been evaluated. The influence of 10 different technical failures was investigated. The study showed that in the optimized system, the most serious faults were i) de-stratification of the storage tanks (23-35% increase in annual purchased electricity) ii) on-off instead of variable speed control of the solar circulation pump (1-22% increase) and iii) reduction in heat pump performance (7-21%). These numbers of course depend on the initial assumptions, but still they show the magnitude of performance reduction some failures can achieve. Therefore, these parameters need to be considered during the implementation of such a system.