This work demonstrated that visible absorbance spectroscopy can track the dissolution of neodymium and erbium oxide in an organic solution containing tributyl phosphate and nitrates. The formation of an aqueous phase was unexpected but an important phenomenon to consider when developing a metal oxide dissolution in organic solution flowsheet. Since the metal oxide appeared to completely dissolve into either the organic or newly formed aqueous phase, dissolution (extraction) rates should be easier to determine.

The authors would like to acknowledge the support of the SRNL Glass Shop for not only constructing but helping to improve the design of glassware used in the dissolution experiments for the U-10Mo scrap recovery flowsheet development. The Glass Shop was able to modify equipment designs and refabricate needed glassware within a matter of days which allowed the project to proceed on schedule.

The dissolution rates of two aluminum alloys (6061-O and 5052-O) were tested to determine which would be able to replace an aluminum alloy that was difficult to procure (6063-T6). The findings of this memo conclude that the dissolution rates of 6061-O and 5052-O are two orders of magnitude slower than 6063-T6. Therefore, it is unlikely that 6061-O and 5052-O would be adequate replacements for 6063-T6 based on similar dissolution rates in a Hg-catalyzed, nitric acid solution. Another area of interest was how temperature variation would influence the dissolution rate of an aluminum alloy (specifically 1100). This separate study found that the dissolution rate of the aluminum alloy below 86 °C was approximately 0.0014 % of the dissolution rate at 94.5◌ ׄ °C and above. Therefore, at or below 86 °C the dissolution rate reduces significantly which translates to much longer dissolution times.

No abstract