It is often desired to functionally grade and/or spatially vary a periodic structure like a photonic crystal or metamaterial, yet no general method for doing this has been offered in the literature. A straightforward procedure is described here that allows many properties of the lattice to be spatially varied at the same time while producing a final lattice that is still smooth and continuous. Properties include unit cell orientation, lattice spacing, fill fraction, and more. This adds many degrees of freedom to a design such as spatially varying the orientation to exploit directional phenomena. The method is not a coordinate transformation technique so it can more easily produce complicated and arbitrary spatial variance. To demonstrate, the algorithm is used to synthesize a spatially variant self-collimating photonic crystal to flow a Gaussian beam around a 90° bend. The performance of the structure was confirmed through simulation and it showed virtually no scattering around the bend that would have arisen if the lattice had defects or discontinuities.

Abstract-In this work, results are given for controlling waves arbitrarily inside a lattice with spatially variant self-collimation. To demonstrate the concept, an unguided beam was made to flow around a 90 • bend without scattering due to the bend or the spatial variance. Control of the field was achieved by spatially varying the orientation of the unit cells throughout a self-collimating photonic crystal, but in a manner that almost completely eliminated deformations to the size and shape of the unit cells. The device was all-dielectric, monolithic, and made from an ordinary dielectric with low relative permittivity (ε r = 2.45). It was manufactured by fused deposition modeling, a form of 3D printing, and its performance confirmed experimentally at around 15 GHz.

Spatially-variant photonic crystals (SVPCs), in which the orientation of the unit cell changes as a function of position, are shown to be capable of abruptly controlling light beams using just low index materials and can be made to have high polarization selectivity. Multi-photon direct laser writing in the photo-polymer SU-8 was used to fabricate three-dimensional SVPCs that direct the flow of light around a 90 degree bend. The lattice spacing and fill factor were maintained nearly constant throughout the structure. The SVPCs were characterized at a wavelength of 2.94 μm by scanning the faces with optical fibers and the results were compared to electromagnetic simulations. The lattices were shown to direct infrared light of one polarization through sharp bends while the other polarization propagated straight through the SVPC. This work introduces a new scheme for controlling light that should be useful for integrated photonics.

One contribution of 14 to a Theo Murphy meeting issue 'Spatial transformations: from fundamentals to applications' .

Self-collimation in photonic crystals has received a lot of attention in the literature, partly due to recent interest in silicon photonics, yet no performance metrics have been proposed. This paper proposes a figure of merit (FOM) for self-collimation and outlines a methodical approach for calculating it. Performance metrics include bandwidth, angular acceptance, strength, and an overall FOM. Two key contributions of this work include the performance metrics and identifying that the optimum frequency for self-collimation is not at the inflection point. The FOM is used to optimize a planar photonic crystal composed of a square array of cylinders. Conclusions are drawn about how the refractive indices and fill fraction of the lattice impact each of the performance metrics. The optimization is demonstrated by simulating two spatially variant self-collimating photonic crystals, where one has a high FOM and the other has a low FOM. This work gives optical designers tremendous insight into how to design and optimize robust self-collimating photonic crystals, which promises many applications in silicon photonics and integrated optics.