A molecular layer-by-layer (mLbL) deposition process is demonstrated to synthesize conformal coatings of crosslinked polyamide. This process controls the rapid reaction of trimesoyl chloride and m-phenylene diamine, unlike interfacial polymerization techniques which produce rough films and poorly defined network structure. Layer-by-layer polyamide films appear structurally similar to interfacially polymerized films with a linear film growth rate of %0.9 nm per cycle. Films made by mLbL deposition show a 70-fold decrease in surface roughness as compared to a commercial, interfacially polymerized polyamide. Surface chemistry could be controlled based on which reaction step was performed last, leading to amine or carboxylic acid rich surfaces. With the ability to control chemical structure throughout the crosslinked network, this technique provides new routes to build polyamide films and improve analysis techniques for commercial applications such as reverse osmosis membranes.

Herein we report nano-molding proteins for the fabrication of protein PRINT particles of monodisperse size and shape. Lyophilized protein particles are generally highly dispersed in particle size, aggregated, and often made through costly and complicated processes. Attempts to engineer monodisperse, discrete protein particles using wet-milling, spray-freeze-drying, microemulsion, or super critical fluid methods have realized little success. The PRINT technology enables a gentle, facile route to monodisperse particles of 100% protein as small as 200 nm cylinders. Protein PRINT particles of any shape and size are effortlessly achievable. Our research efforts include making PRINT particles composed of albumin and albumin 0.5 wt % siRNA, and Abraxane, the gold standard therapeutic used in metastatic breast cancer.

We utilize a vapor deposition setup and cross-diffusion of functionalized chlorosilanes under dynamic vacuum to generate a nearly linear gradient in surface energy and composition on a silicon substrate. The gradient can be tuned by manipulating chlorosilane reservoir sizes and positions, and the gradient profile is independent of time as long as maximum coverage of the substrate is achieved. Our method is readily amenable to the creation of gradients on other substrate surfaces, due to the use of vapor deposition, and with other functionalities, due to our use of functionalized chlorosilanes. Our gradients were characterized using contact angle measurements and X-ray photoelectron spectroscopy. From these measurements, we were able to correlate composition, contact angle, and surface energy. We generated a nearly linear gradient with a range in mole fraction of one component from 0.15 to 0.85 (34 to 40 mJ/m(2) in surface energy) to demonstrate its utility in a block copolymer thin film morphology study. Examination of the copolymer thin film surface morphology with optical and atomic force microscopy revealed the expected morphological transitions across the gradient.