We adopted (111)-oriented Cu with high surface diffusivity to achieve low-temperature and low-pressure Cu/SiO2 hybrid bonding. Electroplating was employed to fabricate arrays of Cu vias with 78% (111) surface grains. The bonding temperature can be lowered to 200 °C, and the pressure is as low as 1.06 MPa. The bonding process can be accomplished by a 12-inch wafer-to-wafer scheme. The measured specific contact resistance is 1.2 × 10−9 Ω·cm2, which is the lowest value reported in related literature for Cu-Cu joints bonded below 300 °C. The joints possess excellent thermal stability up to 375 °C. The bonding mechanism is also presented to provide more understanding on hybrid bonding.

No abstract

Cu-Cu bonding has the potential to break through the extreme boundary of scaling down chips’ I/Os into the sub-micrometer scale. In this study, we investigated the effect of 2-step bonding on the shear strength and electrical resistance of Cu-Cu microbumps using highly <111>-oriented nanotwinned Cu (nt-Cu). Alignment and bonding were achieved at 10 s in the first step, and a post-annealing process was further conducted to enhance its bonding strength. Results show that bonding strength was enhanced by 2–3 times after a post-annealing step. We found 50% of ductile fractures among 4548 post-annealed microbumps in one chip, while the rate was less than 20% for the as-bonded counterparts. During the post-annealing, interfacial grain growth and recrystallization occurred, and the bonding interface was eliminated. Ductile fracture in the form of zig-zag grain boundary was found at the original bonding interface, thus resulting in an increase in bonding strength of the microbumps.

No abstract

No abstract