No abstract

Surfactant alternating gas (SAG) is often the injection strategy used for injecting foam into a reservoir. However, liquid injectivity can be very poor in SAG, and fracturing of the well can occur. Coreflood studies of liquid injectivity directly following foam injection have been reported. We conducted a series of coreflood experiments to study liquid injectivity under conditions more like those near an injection well in a SAG process in the field (i.e., after a period of gas injection). Our previous experimental results suggest that the injectivity in a SAG process is determined by propagation of several banks. However, there is no consistent approach to modeling liquid injectivity in a SAG process. The Peaceman equation is used in most conventional foam simulators for estimating the wellbore pressure and injectivity. In this paper, we propose a modeling approach for gas and liquid injectivity in a SAG process on the basis of our experimental findings. The model represents the propagation of various banks during gas and liquid injection. We first compare the model predictions for linear flow with the coreflood results and obtain good agreement. We then propose a radial-flow model for scaling up the core-scale behavior to the field. The comparison between the results of the radial-propagation model and the Peaceman equation shows that a conventional simulator based on the Peaceman equation greatly underestimates both gas and liquid injectivities in a SAG process. The conventional simulator cannot represent the effect of gas injection on the subsequent liquid injectivity, especially the propagation of a relatively small region of collapsed foam near an injection well. The conventional simulator's results can be brought closer to the radial-flow-model predictions by applying a constant negative skin factor. The work flow described in this study can be applied to future field applications. The model we propose is based on a number of simplifying assumptions. In addition, the model would need to be fitted to coreflood data for the particular surfactant formulation, porous medium, and field conditions of a particular application. The adjustment of the simulator to better fit the radial-flow model also would depend, in part, on the grid resolution of the near-well region in the simulation.

Summary A surfactant alternating gas (SAG) process is often the injection method for foam, on the basis of its improved injectivity over direct foam injection. In a previous study, we reported coreflood experiments on liquid injectivity after foam flooding and liquid injectivity after injection of a gas slug following steady-state foam. Results showed that a period of gas injection is important for the subsequent liquid injectivity. However, the effects of multiple gas and liquid slugs were not explored. In this paper, we present a coreflood study of injectivities of multiple gas and liquid slugs in an SAG process in a field core. Nitrogen and surfactant solution are either coinjected or injected separately into the sandstone core sample. The experiments are conducted at an elevated temperature of 90°C with a backpressure of 40 bar. Differential pressures are measured to quantify gas and liquid injectivities. Computed tomography (CT) scanning is applied to relate water saturation to mobility. During the injection of a large gas slug following foam, a bank in which foam completely collapses or greatly weakens forms near the inlet and propagates slowly downstream. During the subsequent period of liquid injection, liquid flows through the collapsed-foam bank much more easily than further downstream. Beyond the collapsed-foam region, liquid first imbibes into the whole cross section. In this region, liquid flows mainly through a finger of high liquid saturation. Our CT results suggest a revision of our earlier interpretation; the process of gas dissolution does not merely follow fingering but is evidently directly involved in the fingering process. Our results suggest that, in radial flow, the small region of foam collapse very near the well greatly improves injectivity. The subsequent gas and liquid slugs behave near the wellbore, affecting injectivity, in a way similar to the first slugs. Thus, the behavior and modeling of the first gas slug and first subsequent liquid slug is representative of near-well behavior in an SAG process. The trends observed in our previous work are reproduced in a low-permeability field core.

No abstract

No abstract