An ECU hardware-in-loop simulation system for electronic-controlled engine in better real-time and augmentability is built. We establish a dynamic average model of the electronic-controlled engine and put emphasis on analysing its fuel and oil slick modelmass flow model of intake manifold air and the sub-model of inlet manifold pressure. The engine model has fewer parameters and lower orders in order to adjust and set parameters; We propose a building program based on virtual instrument technology and adopts the chip TMS320F2812-DSP to design a signal interface system used to achieve the simulation for sensor signal and the collection of ECU output signal. Through the verification of simulating experimental data, it's proved that the established model of electronic-controlled engine has suitable steps and good real-time performance, building a good foundation for further experimental design and research in the future.

In many engineering applications for vibration detection, some applications cant be field measurements, or cant be long-term monitoring because of the influence of geography, the weather or other special factor. This paper put forward a kind of design project based on the wireless technology which can monitor vibration long range. This system can carry a detective of a target for a long time far away based on an actual application test. At the same time, it can accurately respond to the Vibration of the monitored object and availably solve the problem that traditional vibration examination system is influenced by environment factors. Furthermore, it expands the applied realm of vibration monitoring system.

Contrary to the problem that automobile switches have various kinds and large differences in the structure and performance so that traditional testing methods have been unable to meet the testing requirements of high performance switches, the paper designs a new detection system used to detect the functions of general auto switches which applies the developing environment LabVIEW based on virtual instrument technology and adopts the technology of embedded observe and control system. Using PC as the host computer, the system adopts the LabVIEW8.5 to compile a real-time monitoring system with good human-computer interface; S3C2440-ARM9 processor is used as the main controller of observe and control system in the inferior computer which collects output current signal when the circuit is conducted after switch is pressed. After the coding process of LwIP software protocol and the drive of Ethernet controller DM9000, the signal is transmitted to PC through Ethernet interface. Compared with conventional testing measures, this system greatly improves the real-time performance as well as working efficiency of detecting switch functions and reduces the corresponding human and material resources.