No abstract

The optimization of dye-sensitized solar cells, especially the design of nanoporous TiO2 film microstructure, is an urgent problem for high efficiency and future commercial applications. However, up to now, little attention has been focused on the design of nanoporous TiO2 microstructure for a high efficiency of dye-sensitized solar cell modules. The optimization and design of TiO2 photoelectrode microstructure are discussed in this paper. TiO2 photoelectrodes with three different layers, including layers of small pore size films, larger pore size films, and light-scattering particles on the conducting glass with the desirable thickness, were designed and investigated. Moreover, the photovoltaic properties showed that the different porosities, pore size distribution, and BET surface area of each layer have a dramatic influence on short-circuit current, open-circuit voltage, and fill factor of the modules. The optimization and design of TiO2 photoelectrode microstructure contribute a high efficiency of DSC modules. The photoelectric conversion efficiency around 6% with 15 x 20 cm2 modules under illumination of simulated AM1.5 sunlight (100 mW/cm2) and 40 x 60 cm2 panels with the same performance tested outdoor have been achieved by our group.

Imaging'' biomass conversion: pyrolysis is the first reaction involved in all thermal processes for biofuels and green chemicals production. Synchrotron light ionisation and mass spectrometry is used for the first time to investigate biomass pyrolysis. The soft and tunable ionisation source coupled with ab initio calculations reveals chemical mechanisms and new major intermediate species. This methodology could be extended to the thermal and catalytic conversion of all other materials. Primary volatile products are analysed online as a function of photon energy, biomass composition (cellulose, xylan, lignin), reactor temperature and time of conversion. Hydroxyacetaldehyde was detected at very minor yields for cellulose pyrolysis confirming that it is a secondary product. The effect of cellulose structure and ash content on primary tar formation was also studied. The mechanism of levoglucosan dissociative photoionisation is depicted. A new major intermediate product which could be a precursor of furanone-based species from cellulose is evidenced thanks to the soft ionisation and MSMS structural analysis of ions. Different lignin markers and evolutions upon time of conversion are shown for miscanthus and oak pyrolysis.