Thin stillage contains organic and inorganic compounds, some of which may be valuable fermentation coproducts. This study describes a thorough analysis of the major solutes present in thin stillage as revealed by NMR and HPLC. The concentration of charged and neutral organic compounds in thin stillage was determined by excitation sculpting NMR methods (double pulse field gradient spin echo). Compounds identified by NMR included isopropanol, ethanol, lactic acid, 1,3-propanediol, acetic acid, succinic acid, glycerophosphorylcholine, betaine, glycerol, and 2-phenylethanol. The concentrations of lactic and acetic acid determined with NMR were comparable to those determined using HPLC. HPLC and NMR were complementary, as more compounds were identified using both methods. NMR analysis revealed that stillage contained the nitrogenous organic compounds betaine and glycerophosphorylcholine, which contributed as much as 24% of the nitrogen present in the stillage. These compounds were not observed by HPLC analysis.

No abstract

Chickpea and other pulses are commonly sold as canned products packed in a thick solution or a brine. This solution has recently been shown to produce stable foams and emulsions, and can act as a thickener. Recently interest in this product has been enhanced through the internet where it is proposed that this solution, now called aquafaba by a growing community, can be used a replacement for egg and milk protein. As aquafaba is both new and being developed by an internet based community little is known of its composition or properties. Aquafaba was recovered from 10 commercial canned chickpea products and correlations among aquafaba composition, density, viscosity and foaming properties were investigated. Proton NMR was used to characterize aquafaba composition before and after ultrafiltration through membranes with different molecular weight cut offs (MWCOs of 3, 10, or 50 kDa). A protocol for electrophoresis, and peptide mass fingerprinting is also presented. Those methods provided valuable information regarding components responsible for aquafaba functional properties. This information will allow the development of practices to produce standard commercial aquafaba products and may help consumers select products of superior or consistent utility.

Summary Flaxseed gum (FG) was prepared from six Canadian flaxseed (Linum usitatissimum L.) cultivars. Yield, neutral sugar content, acidic sugar content and protein content varied significantly among cultivar FG extracts. Zeta potential (−16.4 to −27.4 mV) and rheological properties of solution were cultivar dependent. Solutions prepared with CDC Glas FG had the highest viscosity (2.984 Pa•s), while CDC Sorrel produced the lowest (0.048 Pa•s). FG solutions exhibited pseudoplastic shear‐thinning behaviour. Viscosity of FG solution increased with concentration, while viscosity and pseudoplasticity decreased with increased temperature. NaCl addition decreased solution viscosity while adding sucrose increased viscosity. FG solutions prepared from Flanders and CDC Sorrel had the highest and lowest emulsion activity index, respectively, while solutions of CDC Arras and CDC Bethune FG had the lowest and highest emulsion stability, respectively. Findings presented here provide information that could enable greater utilisation in food, cosmetic and pharmaceutical industries as thickeners and/or emulsifiers.

No abstract