No abstract

The controlled assembly of nanowires is a key challenge in the development of a range of bottom-up devices. Recent advances in the post-growth assembly of nanowires and carbon nanotubes have led to alignment ratios of 80-95% for a misalignment angle of ±5° (refs 5, 12, , 14) and allowed various multiwire devices to be fabricated. However, these methods still create a significant number of crossing defects, which restricts the development of device arrays and circuits based on single nanowires/nanotubes. Here, we show that a nanocombing assembly technique, in which nanowires are anchored to defined areas of a surface and then drawn out over chemically distinct regions of the surface, can yield arrays with greater than 98.5% of the nanowires aligned to within ±1° of the combing direction. The arrays have a crossing defect density of ∼0.04 nanowires per µm and efficient end registration at the anchoring/combing interface. With this technique, arrays of single-nanowire devices are tiled over chips and shown to have reproducible electronic properties. We also show that nanocombing can be used for laterally deterministic assembly, to align ultralong (millimetre-scale) nanowires to within ±1° and to assemble suspended and crossed nanowire arrays.

Memristive devices are promising candidates to emulate biological computing. However, the typical switching voltages (0.2-2 V) in previously described devices are much higher than the amplitude in biological counterparts. Here we demonstrate a type of diffusive memristor, fabricated from the protein nanowires harvested from the bacterium Geobacter sulfurreducens, that functions at the biological voltages of 40-100 mV. Memristive function at biological voltages is possible because the protein nanowires catalyze metallization. Artificial neurons built from these memristors not only function at biological action potentials (e.g., 100 mV, 1 ms) but also exhibit temporal integration close to that in biological neurons. The potential of using the memristor to directly process biosensing signals is also demonstrated.

Biological sensory organelles are often structurally optimized for high sensitivity. Tactile hairs or bristles are ubiquitous mechanosensory organelles in insects. The bristle features a tapering spine that not only serves as a lever arm to promote signal transduction, but also a clever design to protect it from mechanical breaking. A hierarchical distribution over the body further improves the signal detection from all directions. We mimic these features by using synthetic zinc oxide microparticles, each having spherically-distributed, high-aspect-ratio, and high-density nanostructured spines resembling biological bristles. Sensors based on thin films assembled from these microparticles achieve static-pressure detection down to 0.015 Pa, sensitivity up to 121 kPa−1, and a strain gauge factor >104, showing supreme overall performance. Other properties including a robust cyclability >2000, fast response time ~7 ms, and low-temperature synthesis compatible to various integrations further indicate the potential of this sensor technology in applying to wearable technologies and human interfaces.

Relaxation and dephasing of hole spins are measured in a gate-defined Ge/Si nanowire double quantum dot using a fast pulsed-gate method and dispersive readout. An inhomogeneous dephasing time T2* 0.18 μs exceeds corresponding measurements in III–V semiconductors by more than an order of magnitude, as expected for predominately nuclear-spin-free materials. Dephasing is observed to be exponential in time, indicating the presence of a broadband noise source, rather than Gaussian, previously seen in systems with nuclear-spin-dominated dephasing.