In this study, we propose an algorithm that uses an improved Minimum Spanning Tree algorithm and a modified Canny edge detector to segment images that contain a considerable amount of noises. First, we use our modified Canny operator to pre-process an image, and record the obtained object boundary information; then, we apply the improved Minimum Spanning Tree algorithm to associate the above information with boundary points in order to separate edges into two classes in the image, namely the inner and boundary regions. In particular, Minimum Spanning Tree algorithm is improved by using Fractional differential and combining the functions of the intra-regional and interregional differences with a function for edge weights. Based on the experimental results, compared with the other four exiting algorithms, the new algorithm has the higher accuracy and the better effect for noised image segmentation.

No abstract

No abstract

Quantum dots (QDs) are one kind of photoluminescent materials with excellent properties, such as adjustable spectrum, narrow full width at half maximum (FWHM), and high color gamut. In this paper, a photoluminescent QDs printing paste suitable for light guide dots array applied in the backlight for liquid crystal display (LCD) was presented. The QDs printing paste was first prepared and characterized with different kinds of solvents. Then, triphenyl phosphite (TPP), a kind of antioxygen, was added into the QDs printing paste to improve the stability of the QDs printing paste. Finally, a QDs light guide plate (LGP) was fabricated by screen printing with QDs printing paste added with silicon dioxide (SiO 2 ) light scattering particles. The color gamut of QDsLGP arrived 131.6%NTSC due to light scattering interaction between blue LED, red QDs, green QDs, and SiO 2 particles. The results showed that the QDs-chloroform printing paste had uniform light output and the highest photoluminescent peak intensity. Therefore, the composite screen printing paste has wide application prospects in the backlight of LCD, with the advantages of simple process, high production efficiency, and low cost.

This paper proposes a kind of periodic complex ramp pulse driving waveform in the electrowetting display system with suitable viscosity ink. Firstly, considering the fluid-motion characteristics of different viscosity inks, the relationship between the contact angle and viscosity of inks in the liquid-oil-solid three-phase contact display system is calculated to obtain the suitable viscosity range and driving voltage range. Secondly, the physical model of ink motion with different viscosity is established by COMSOL simulation. Then, During the ink shrinkage movement after applying voltage, the change of the meniscus height at the oil-liquid interface is calculated. Finally, the appropriate viscosity range of the ink movement is verified and obtained based on the meniscus height. On this basis, after applying the driving voltage of different amplitude and frequency respectively, the ink movement situation is observed to design a suitable driving waveform. The results show that when the viscosity of ink fluid is between 0.005 and 0.015Pa·s, the higher the voltage amplitude and the lower the frequency, the higher the meniscus height of ink shrinkage, which is consistent with the characteristics of magenta ink tested in the experiment. Experimental tests show that the driving waveform designed in this paper can not only suppress the phenomenon of oil film splitting, backflow and contact angle saturation hysteresis, but also improve the ink response speed and pixel aperture ratio, in which the aperture ratio is increased to 68.69%. This research is of great significance to optimize the structure of fluid material and the design of driving in electrowetting display.