A simple and green route was developed for the first time to produce fluorescent graphitic carbon nitride (F-g-C₃N₄) by hydrothermal treatment of bulk g-C₃N₄. The produced F-g-C₃N₄ dots have blue emission and a high quantum yield, and were applied as a very effective fluorescent probe for label-free selective and sensitive detection of Cu(2+) and Fe(3+) ions; the limits of detection were as low as 0.5 nM and 1.0 nM, respectively. By using sodium hexametaphosphate (SHPP) as a masking agent of Fe(3+), Cu(2+) was exclusively detected in the presence of Fe(3+) ions. Cu(2+) and Fe(3+) ions in real water samples were also detected successfully. This exceptional fluorescent performance makes the probes based on F-g-C₃N₄ dots attractive for highly sensitive detection of Cu(2+) and Fe(3+) ions in real water.
Water-soluble magnetic-functionalized graphitic carbon nitride (g-C3N4) composites were synthesized successfully by in situ decorating spinel ZnFe2O4 nanoparticles on g-C3N4 sheets (CN-ZnFe) through a one-step solvothermal method. The magnetic properties of CN-ZnFe can be effectively controlled via tuning the coverage density and the size of ZnFe2O4 nanoparticles. The results indicate that the CN-ZnFe exhibits excellent photocatalytic efficiency for methyl orange (MO) and fast separation from aqueous solution by magnet. Interestingly, the catalytic performance of the CN-ZnFe is strongly dependent on the loading of ZnFe2O4. The optimum activity of 160CN-ZnFe photocatalyst is almost 6.4 and 5.6 times higher than those of individual g-C3N4 and ZnFe2O4 toward MO degradation, respectively. By carefully investigating the influence factors, a possible mechanism is proposed and it is believed that the synergistic effect of g-C3N4 and ZnFe2O4, the smaller particle size, and the high solubility in water contribute to the effective electron-hole pairs separation and excellent photocatalytic efficiency. This work could provide new insights that g-C3N4 sheets function as good support to develop highly efficient g-C3N4-based magnetic photocatalysts in environmental pollution cleanup.
The effects of pH, ionic strength, and temperature on sorption of Eu(III) on attapulgite were investigated in the presence and absence of fulvic acid (FA) and humic acid (HA). The results indicated that the sorption of Eu(III) on attapulgite was strongly dependent on pH and ionic strength, and independent of temperature. In the presence of FA/HA, Eu(III) sorption was enhanced at pH < 4, decreased at pH range of 4-6, and then increased again at pH > 7. The X-ray photoelectron spectroscopy (XPS) analysis suggested that the sorption of Eu(III) might be expressed as is identical to X3Eu0, is identical to S(w)OHEu3+, and is identical to SOEu-OOC-/HA in the ternary Eu/HN/attapulgite system. The extended X-ray absorption fine structure (EXAFS) analysis of Eu-HA complexes indicated that the distances of d(Eu-O) decreased from 2.415 to 2.360 angstroms with increasing pH from 1.76 to 9.50, whereas the coordination number (N) decreased from approximately 9.94 to approximately 8.56. Different complexation species were also found for the different addition sequences of HA and Eu(III) to attapulgite suspension. The results are important to understand the influence of humic substances on Eu(III) behavior in the natural environment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.