In this study, we used data from multiple sensors onboard NASA Aqua satellite to conduct a 10-year (2002-2011) remote sensing of microwave emissivity difference vegetation index (EDVI) over China. We investigated the spatial and temporal variations of EDVI in tropical and subtropical evergreen forest, deciduous forest, rice and wheat farmlands, grassland, and montane vegetation regions. The average of China's EDVI is positive in dense vegetation regions and negative in sparse vegetation regions, depending on the proportion of bare soil and open water. In all selected studying regions, the seasonal variation of EDVI follows the trend of vegetation phenology, even in regions with large proportion of open water. EDVI is positively correlated to the greenness of vegetation (normalized difference vegetation index [NDVI]) with certain phase difference in their seasonal cycle. In autumn, EDVI begins to decline earlier and faster than NDVI. In tropical rainforest, EDVI also starts to increase earlier than NDVI in spring. The large-scale spatial distribution of EDVI under clear sky and cloudy sky is similar. In montane vegetation regions, EDVI under heavy clouds (90% fraction) conditions is significantly greater than that under clear sky (10% fraction), indicating a possible cloud induced enhancement of vegetation water content. In forests and croplands in the plains, such effect is not remarkable.

Fire omission and commission errors, and the accuracy of fire radiative power (FRP) from satellite moderate-resolution impede the studies on fire regimes and FRP-based fire emissions estimation. In this study, we compared the accuracy between the extensively used 1-km fire product of MYD14 from the Moderate Resolution Imaging Spectroradiometer (MODIS) and the 375-m fire product of VNP14IMG from the Visible Infrared Imaging Radiometer Suite (VIIRS) in Northeastern Asia using data from 2012–2017. We extracted almost simultaneous observation of fire detection and FRP from MODIS-VIIRS overlapping orbits from the two fire products, and identified and removed duplicate fire detections and corresponding FRP in each fire product. We then compared the performance of the two products between forests and low-biomass lands (croplands, grasslands, and herbaceous vegetation). Among fire pixels detected by VIIRS, 65% and 83% were missed by MODIS in forests and low-biomass lands, respectively; whereas associated omission rates by VIIRS for MODIS fire pixels were 35% and 53%, respectively. Commission errors of the two fire products, based on the annual mean measurements of burned area by Landsat, decreased with increasing FRP per fire pixel, and were higher in low-biomass lands than those in forests. Monthly total FRP from MODIS was considerably lower than that from VIIRS due to more fire omission by MODIS, particularly in low-biomass lands. However, for fires concurrently detected by both sensors, total FRP was lower with VIIRS than with MODIS. This study contributes to a better understanding of fire detection and FRP retrieval performance between MODIS and its successor VIIRS, providing valuable information for using those data in the study of fire regimes and FRP-based fire emission estimation.

Microwave land surface emissivity (MLSE) is an important geophysical parameter to determine the microwave radiative transfer over land and has broad applications in satellite remote sensing of atmospheric parameters (e.g., precipitation, cloud properties), land surface parameters (e.g., soil moisture, vegetation properties), and the parameters of interactions between atmosphere and terrestrial ecosystem (e.g., evapotranspiration rate, gross primary production rate). In this study, MLSE in China under both clear and cloudy sky conditions was retrieved using satellite passive microwave measurements from Aqua Advanced Microwave Scanning Radiometer-Earth Observing System (AMSR-E), combined with visible/infrared observations from Aqua Moderate Resolution Imaging Spectroradiometer (MODIS), and the European Centre for Medium-Range Weather Forecasts (ECMWF) atmosphere reanalysis dataset of ERA-20C. Attenuations from atmospheric oxygen and water vapor, as well as the emissions and scatterings from cloud particles are taken into account using a microwave radiation transfer model to do atmosphere corrections. All cloud parameters needed are derived from MODIS visible and infrared instantaneous measurements. Ancillary surface skin temperature as well as atmospheric temperature-humidity profiles are collected from ECMWF reanalysis data. Quality control and sensitivity analyses were conducted for the input variables of surface skin temperature, air temperature, and atmospheric humidity. The ground-based validations show acceptable biases of primary input parameters (skin temperature, 2 m air temperature, near surface relative humidity, rain flag) for retrieving using. The subsequent sensitivity tests suggest that 10 K bias of skin temperature or observed brightness temperature may result in a 4% (~0.04) or 7% (0.07) retrieving error in MLSE at 23.5 GHz. A nonlinear sensitivity in the same magnitude is found for air temperature perturbation, while the sensitivity is less than 1% for 300 g/m2 error in cloud water path. Results show that our algorithm can successfully retrieve MLSE over 90% of the satellite detected land surface area in a typical cloudy day (cloud fraction of 64%), which is considerably higher than that of the 29% area by the clear-sky only algorithms. The spatial distribution of MLSE in China is highly dependent on the land surface types and topography. The retrieved MLSE is assessed by compared with other existing clear-sky AMSR-E emissivity products and the vegetation optical depth (VOD) product. Overall, high consistencies are shown for the MLSE retrieved in this study with other AMSR-E emissivity products across China though noticeable discrepancies are observed in Tibetan Plateau and Qinling-Taihang Mountains due to different sources of input skin temperature. In addition, the retrieved MLSE exhibits strong positive correlations in spatial patterns with microwave vegetation optical depth reported in the literature.

No abstract

Understanding the cloud impact on forest evapotranspiration (ET) is crucial for studying the interaction of vegetation‐cloud‐atmosphere. Combining long‐term (2003–2010) satellite passive microwave observations and in‐situ measurements, a non‐linear response of canopy‐scale ET to cloud increase was found at a temperate forest in Northeast China. As cloud increased, an initial enhancement (4%–10%) in ET occurred under less cloudy sky, while a significant reduction (>20%) in ET occurred under more cloudy sky. The phenomenon existed under both high and low vegetation water content (VWC) indicated by satellite microwave emissivity difference vegetation index (EDVI). Analysis showed that this was the combined effect from the enhancement (5%–30%) in evaporative fraction (EF) and the reduction (5%–50%) in net radiation under cloud increase. Decoupling analysis based on coefficients (ρ) of path analysis model showed that enhanced EF (ρ > 0.61) rather than radiation (ρ < 0.47) dominated the ET enhancement under less cloudy sky, while the control of reduced radiation became stronger (ρ > 0.63) and could not be compensated by increased EF (ρ < 0.48) under more cloudy sky. EF enhancement under clouds was strongly correlated with the decline in canopy resistance (Rs) which was dominated by vapor pressure deficit (VPD). Higher VWC increased ET via reducing Rs and enlarging EF. This positive effect of VWC was more noticeable under less cloudy sky. Associated mechanisms could be related to the dynamic controls of plant physiology and environmental conditions induced by VWC and clouds. This study highlighted the dynamic effect of clouds and VWC on forest ET and improved our knowledge of vegetation‐cloud interactions.