[1] Sea-salt aerosol (SSA) is an important constituent of natural marine aerosol to which anthropogenic aerosols must be compared when assessing their climatic influence. Size distributions of particles, produced by bubbles from coastal oceanic breaking waves, were found to have sizes as small as 0.01 mm, with 60% smaller than 0.1 mm diameter. The thermal stability of these particles and their growth factor measured under increasing humidity indicate that most are sea salt. These SSA size distributions were used in conjunction with the measured number flux for bubbles from coastal breaking waves to develop a new sea-salt source function. This source function and the associated SSA flux compare favorably with previously published estimates available for sizes larger than 0.5 mm but extend the source function down to much smaller sizes. When this SSA flux is applied to oceanic whitecaps that have a highly nonlinear dependence on wind speed, it implies strong regional and temporal differences in the open ocean surface number flux. In marine regions with little continental impact we estimate that this SSA flux can contribute $5-90% of the marine cloud condensation nuclei (CCN), with the rest accounted for by the flux of aerosol entrained from the free troposphere. These two fluxes are large enough to account for commonly observed aerosol and CCN concentrations in the clean MBL without requiring a nucleation source in the MBL. These observations have significant implications for modeling marine aerosol concentrations and evolution.Citation: Clarke, A. D., S. R. Owens, and J. Zhou (2006), An ultrafine sea-salt flux from breaking waves: Implications for cloud condensation nuclei in the remote marine atmosphere,
Abstract. The concentration, size, and composition of non-refractory submicron aerosol (NR-PM1) was measured over Mexico City and central Mexico with a High-Resolution Time-of-Flight Aerosol Mass Spectrometer (HR-ToF-AMS) onboard the NSF/NCAR C-130 aircraft as part of the MILAGRO field campaign. This was the first aircraft deployment of the HR-ToF-AMS. During the campaign the instrument performed very well, and provided 12 s data. The aerosol mass from the AMS correlates strongly with other aerosol measurements on board the aircraft. Organic aerosol (OA) species dominate the NR-PM1 mass. OA correlates strongly with CO and HCN indicating that pollution (mostly secondary OA, SOA) and biomass burning (BB) are the main OA sources. The OA to CO ratio indicates a typical value for aged air of around 80 μg m−3 (STP) ppm−1. This is within the range observed in outflow from the Northeastern US, which could be due to a compensating effect between higher BB but lower biogenic VOC emissions during this study. The O/C atomic ratio for OA is calculated from the HR mass spectra and shows a clear increase with photochemical age, as SOA forms rapidly and quickly overwhelms primary urban OA, consistent with Volkamer et al. (2006) and Kleinman et al. (2008). The stability of the OA/CO while O/C increases with photochemical age implies a net loss of carbon from the OA. BB OA is marked by signals at m/z 60 and 73, and also by a signal enhancement at large m/z indicative of larger molecules or more resistance to fragmentation. The main inorganic components show different spatial patterns and size distributions. Sulfate is regional in nature with clear volcanic and petrochemical/power plant sources, while the urban area is not a major regional source for this species. Nitrate is enhanced significantly in the urban area and immediate outflow, and is strongly correlated with CO indicating a strong urban source. The importance of nitrate decreases with distance from the city likely due to evaporation. BB does not appear to be a strong source of nitrate despite its high emissions of nitrogen oxides, presumably due to low ammonia emissions. NR-chloride often correlates with HCN indicating a fire source, although other sources likely contribute as well. This is the first aircraft study of the regional evolution of aerosol chemistry from a tropical megacity.
Abstract. The organic fraction of atmospheric aerosols contains a multitude of compounds and usually only a small fraction can be identified and quantified. However, a limited number of representative organic compounds can be used to describe the water-soluble organic fraction. In this work, initiated within the EU 5FP project SMOCC, four mixtures containing various amounts of inorganic salts (ammonium sulfate, ammonium nitrate, and sodium chloride) and three model organic compounds (levoglucosan, succinic acid and fulvic acid) were studied. The interaction between water vapor and aerosol particles was studied at different relative humidities: at subsaturation using a hygroscopic tandem differential mobility analyzer (H-TDMA) and at supersaturation using a cloud condensation nuclei spectrometer (CCN spectrometer). Surface tensions as a function of carbon concentrations were measured using a bubble tensiometer. Parameterizations of water activity as a function of molality, based on hygroscopic growth, are given for the pure organic compounds and for the mixtures, indicating van't Hoff factors around 1 for the organics. The Zdanovskii-Stokes-Robinson (ZSR) mixing rule was tested on the hygroscopic growth of the mixtures and it was found to adequately explain the hygroscopic growth for 3 out of 4 mixtures, when the limited solubility of succinic acid is taken into account. One mixture containing sodium chloride was studied and showed a pronounced deviation from the ZSR mixing rule. Critical supersaturations calculated using the parameterizations of water activity and the measured surface tensions were compared with those determined experimentally.
Abstract. Aerosol particle number size distributions and hygroscopic properties were measured at a pasture site in the southwestern Amazon region (Rondonia). The measurements were performed 11 September-14 November 2002 as part of LBA-SMOCC (Large scale Biosphere atmosphere experiment in Amazonia -SMOke aerosols, Clouds, rainfall and Climate), and cover the later part of the dry season (with heavy biomass burning), a transition period, and the onset of the wet period.Particle number size distributions were measured with a DMPS (Differential Mobility Particle Sizer, 3-850 nm) and an APS (Aerodynamic Particle Sizer), extending the distributions up to 3.3 µm in diameter. An H-TDMA (Hygroscopic Tandem Differential Mobility Analyzer) measured the hygroscopic diameter growth factors (Gf ) at 90% relative humidity (RH), for particles with dry diameters (d p ) between 20-440 nm, and at several occasions RH scans (30-90% RH) were performed for 165 nm particles. These data provide the most extensive characterization of Amazonian biomass burning aerosol, with respect to particle number size distributions and hygroscopic properties, presented until now. The evolution of the convective boundary layer over the course of the day causes a distinct diel variation in the aerosol physical properties, which was used to get information about the properties of the aerosol at higher altitudes.The number size distributions averaged over the three defined time periods showed three modes; a nucleation mode with geometrical median diameters (GMD) of ∼12 nm, an Aitken mode (GMD=61-92 nm) and an accumulation mode (GMD=128-190 nm). The two larger modes were shifted towards larger GMD with increasing influence from biomass burning.Correspondence to: J. Rissler (jenny.rissler@pixe.lth.se)The hygroscopic growth at 90% RH revealed a somewhat external mixture with two groups of particles; here denoted nearly hydrophobic (Gf ∼1.09 for 100 nm particles) and moderately hygroscopic (Gf ∼1.26). While the hygroscopic growth factors were surprisingly similar over the periods, the number fraction of particles belonging to each hygroscopic group varied more, with the dry period aerosol being more dominated by nearly hydrophobic particles. As a result the total particle water uptake rose going into the cleaner period. The fraction of moderately hygroscopic particles was consistently larger for particles in the accumulation mode compared to the Aitken mode for all periods. Scanning the H-TDMA over RH (30-90% RH) showed no deliquescence behavior. A parameterization of both Gf (RH) and Gf (d p ), is given.
[1] Thermal analysis of aerosol size distributions provided size resolved volatility up to temperatures of 400°C during extensive flights over North America (NA) for the INTEX/ICARTT experiment in summer 2004. Biomass burning and pollution plumes identified from trace gas measurements were evaluated for their aerosol physiochemical and optical signatures. Measurements of soluble ionic mass and refractory black carbon (BC) mass, inferred from light absorption, were combined with volatility to identify organic carbon at 400°C (VolatileOC) and the residual or refractory organic carbon, RefractoryOC. This approach characterized distinct constituent mass fractions present in biomass burning and pollution plumes every 5-10 min. Biomass burning, pollution and dust aerosol could be stratified by their combined spectral scattering and absorption properties. The ''nonplume'' regional aerosol exhibited properties dominated by pollution characteristics near the surface and biomass burning aloft. VolatileOC included most water-soluble organic carbon. RefractoryOC dominated enhanced shortwave absorption in plumes from Alaskan and Canadian forest fires. The mass absorption efficiency of this RefractoryOC was about 0.63 m 2 g À1 at 470 nm and 0.09 m 2 g À1 at 530 nm. Concurrent measurements of the humidity dependence of scattering, g, revealed the OC component to be only weakly hygroscopic resulting in a general decrease in g with increasing OC mass fractions. Under ambient humidity conditions, the systematic relations between physiochemical properties and g lead to a well-constrained dependency on the absorption per unit dry mass for these plume types that may be used to challenge remotely sensed and modeled optical properties.Citation: Clarke, A., et al. (2007), Biomass burning and pollution aerosol over North America: Organic components and their influence on spectral optical properties and humidification response,
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.