Microalgal biomass as renewable energy source is believed to be of great potential for reliable and sustainable biofuels production. However, microalgal biomass production is pinned by harvesting and dewatering stage thus hindering the developing and growing microalgae biotechnology industries. Flotation technology applied in mineral industry could be potentially applied in microalgae harvesting and dewatering, however substantial knowledge on different flotation units is essential. This paper presents an overview on different flotation units as promising cost-effective technologies for microalgae harvesting thus bestowing for further research in development and commercialization of microalgae based biofuels. Dispersed air flotation was found to be less energy consuming. Moreover, Jameson cell flotation and dispersed ozone flotation are believed to be energy efficient microalgae flotation approaches. Microalgae harvesting and dewatering by flotation is still at embryonic stage, therefore extended studies with the focus on life cycle assessment, sustainability of the flotation unit, optimization of the operating parameters using different algal species is imperative. Though there are a number of challenges in microalgae harvesting and dewatering, with well designed and developed cultivation, harvesting/dewatering, extraction and conversion technologies, progressively, microalgae technology will be of great potential for biological carbon sequestration, biofuels and biochemicals production.

Polyunsaturated fatty acids (PUFAs) are highly appreciated on their nutritive value for human health and aquaculture. P. purpureum, one of the red microalgae acknowledged as a promising accumulator of ARA, was chosen as the target algae in the present research. Effects of sodium bicarbonate (0.04-1.2 g/L), temperature (25, 30 and 33 °C) and phosphate (0.00-0.14 g/L) on biomass yield, total fatty acids (TFA) and arachidonic acid (ARA) accumulation were investigated systemically. NaHCO3 dose of 0.8 g/L and moderate temperature of 30 °C were preferred. In addition, TFA and ARA production were significantly enhanced by an appropriate concentration of phosphate, and the highest TFA yield of 666.38 mg/L and ARA yield of 159.74 mg/L were obtained at a phosphate concentration of 0.035 g/L. Interestingly, with phosphate concentration continuing to fall, UFA/TFA and ARA/EPA ratios were increased accordingly, suggesting that phosphate limitation promoted unsaturated fatty acids and arachidonic acid biosynthesis. Low concentration of phosphate may be favored to increase the enzymatic activities of ∆6-desaturase, which played a key role in catalyzing the conversion of C16:0 to C18:2, and thus the selectivity of UFA increased. Meanwhile, the increase of ARA selectivity could be attributed to ω6 pathway promotion and ∆17-desaturase activity inhibition with phosphate limitation. Phosphate limitation strategy enhanced unsaturated fatty acids and ARA biosynthesis in P. purpureum, and can be applied in commercial scale manufacturing and commercialization of ARA.

BackgroundThe microalga Porphyridium purpureum within Rhodophyta abundantly produces several valuable proteins, polysaccharides, pigments and long-chain polyunsaturated fatty acid; it is especially effective in accumulating arachidonic acid (ARA). However, this high ARA yield is always achieved in conditions unfavourable for cell growth. In this study, we present a method for obtaining desirable ARA levels from P. purpureum while simultaneously promoting cell growth using appropriate concentrations of the growth hormone 5-Aminolevulinic acid (5-ALA).ResultsBoth the biomass and the ARA content of P. purpureum were enhanced by stimulation with 20 mg/L 5-ALA, leading to an optimal ARA yield of 170.32 mg/L—a 70.82% increase compared with control conditions. This ARA yield is the highest ever reported for microalgae. Based on variations in the fatty acid composition, total lipids, total proteins, total carbohydrates and pigment content during the cultivation period, we propose that the accumulation of ARA stimulated by 5-ALA occurs at the expense of other UFAs and total proteins, which may be related to decreased zeaxanthin. Lipidomic analysis revealed that triacylglycerols (TAGs) accounted for 47.5 ± 3.6% of all detected lipids, followed by phosphatidylglycerol (PG) and digalactosyldiacylglycerol (DGDG). As the levels of the most abundant TAGs increased under 5-ALA promotion and because 78.1 ± 3.4% (by weight) of detected TAG-branched chains contained ARA, the increase of ARA was mainly caused by TAG accumulation.ConclusionsThis work demonstrated a simple and effective strategy to promote both biomass and ARA yield in P. purpureum by introducing a small amount of 5-ALA. These results are helpful for understanding the microalgae metabolic pathways affected by phytohormones and for guiding the development of bioproducts from microalgae.

Objectives: This study investigated the effect of aeration rate and light intensity on biomass production and total fatty acids (TFA) accumulation by Porphyridium purpureum. The red microalgae is also known to accumulate considerable amount of arachidonic acid (ARA). Results:In artificial seawater medium, the highest yield of TFA (473.44 mg/L) was obtained with the aeration rate of 3 L/min and light intensity of 165 µmol/m 2 s, whilst the highest yield of ARA (115.47 mg/L) was achieved with the aeration rate of 3 L/min and light intensity of 110 µmol/m 2 s. It was found that higher aeration rate led to more biomass and TFA/ARA production. However, higher light intensity could contribute to biomass accumulation, but it was adverse for TFA and ARA biosynthesis. Conclusion:By optimizing two operating factors (i.e., light intensity and aeration rate), TFA and ARA production by P. purpureum was significantly improved. This research provides a potential alternative means for producing ARA.

No abstract