Peri-operative SARS-CoV-2 infection increases postoperative mortality. The aim of this study was to determine the optimal duration of planned delay before surgery in patients who have had SARS-CoV-2 infection. This international, multicentre, prospective cohort study included patients undergoing elective or emergency surgery during October 2020. Surgical patients with pre-operative SARS-CoV-2 infection were compared with those without previous SARS-CoV-2 infection. The primary outcome measure was 30-day postoperative mortality. Logistic regression models were used to calculate adjusted 30-day mortality rates stratified by time from diagnosis of SARS-CoV-2 infection to surgery. Among 140,231 patients (116 countries), 3127 patients (2.2%) had a pre-operative SARS-CoV-2 diagnosis. Adjusted 30-day mortality in patients without SARS-CoV-2 infection was 1.5% (95%CI 1.4-1.5). In patients with a pre-operative SARS-CoV-2 diagnosis, mortality was increased in patients having surgery within 0-2 weeks, 3-4 weeks and 5-6 weeks of the diagnosis (odds ratio (95%CI) 4.1 (3.3-4.8), 3.9 (2.6-5.1) and 3.6 (2.0-5.2), respectively). Surgery performed ≥ 7 weeks after SARS-CoV-2 diagnosis was associated with a similar mortality risk to baseline (odds ratio (95%CI) 1.5 (0.9-2.1)). After a ≥ 7 week delay in undertaking surgery following SARS-CoV-2 infection, patients with ongoing symptoms had a higher mortality than patients whose symptoms had resolved or who had been asymptomatic (6.0% (95%CI 3.2-8.7) vs. 2.4% (95%CI 1.4-3.4) vs. 1.3% (95%CI 0.6-2.0), respectively). Where possible, surgery should be delayed for at least 7 weeks following SARS-CoV-2 infection. Patients with ongoing symptoms ≥ 7 weeks from diagnosis may benefit from further delay.

Spiropyran (SP) mechanophore was synthesized into the soft or hard phase of segmented polyurethanes (SPU) and used as a molecular probe of force and orientation. Upon either tensile stretching or irradiation with UV light the SP-linked segmented polyurethane (SP-SPU) adopt a deep purple coloration and are fluorescent, demonstrating the force and UV-induced formation of the open merocyanine (MC) form of the mechanophore. Order parameters calculated from the anisotropy of the fluorescence polarization of merocyanine (MC) were used to characterize the orientation in each phase.Exploiting the ability of SP to be force activated, the SP-SPUs were also mechanically activated to track the force and orientation in each domain of segmented polyurethane during uniaxial tensile loading.

Magnetic particle imaging (MPI) has recently emerged as a promising non-invasive imaging technique. Engineering of magnetic nanoparticles (MNPs) is effective ways to enhance MPI sensitivity and spatial resolution.