The relationship of structure to optical spectral properties was determined for five types of fluors in a search for an optimum-wavelength shifter to be used as part of the detection systems for high-energy particles from accelerators. In a search for photostable fluors to serve as waveshifters in plastic fibers it was found that the wavelengths of interest, absorption max 410 +/- 10 nm and fluorescence emission max 480 +/- 20 nm, along with other properties, such as high solubility and short fluorescence decay time, could be obtained from fluorophors composed of aromatic rings and vinyl groups only by using amino groups as auxochromes to give bathochromic shifts of wavelengths. Since primary, monoalkyl, and dialkylamino groups were not sufficiently photostable, a number of fluorophores bearing diarylamino groups were investigated. Syntheses of the fluors made use of the Buchwald amination, an improved version of the Emmons-Horner reaction, and other common reactions. The fluor types were the following: a 2-benzoxazolyl-7-(4-diarylamino)fluorene 7, 2-(4-cyanophenyl)-5-(4-aminophenyl)oxazoles 14 and 20, 1,3,5-hexatrienes 24a-d and 26a-c, 1,4-distyrylbenzenes 31d-g and 32a-e, and 2,7-distyrylfluorenes 40a,d-e. The unsymmetrical fluors 7, 14, and 20 were not as bright as the best hexatrienes, distyrylbenzenes, and distyrylfluorenes, which were all symmetrical. Where the 1,6-diaryl-1,3,5-hexatrienes 24a-d had high fluorescence quantum yield (Phi(f)), the 1,1,6,6-tetraryl-1,3,5-hexatrienes 26a-c had both lower epsilon and Phi(f). Where the 1,4-distyrylbenzenes 31d-g had high Phi(f), the 1,4-bis(2-phenylstyryl)benzenes 32a-e had Phi(f) = 0. Diarylamino groups as auxofluors conferred higher photochemical stability than dialkylamino groups on similar fluorophores. The 1,4-distyrylbenzenes 31d,e and the 2,7-distyrylfluorenes 40d,ehad the most desirable properties overall, which included fast decay times of 2 ns. Computer simulations predicted absorption and emission wavelengths fairly well, but were of little help for the prediction of brightness, stability, Phi(f), or decay time.

Absorption and fluorescence emission spectral data, as well as fluorescence quantum yields (Φf), were determined for 41p-oligophenylene compounds containing 2-6, 8, and 10 benzene rings. Of 29 compounds containing carbon-bridged rings (fluorenes), 28 were dialkylated on each bridge for improved solubility and photostability. Absorption maxima for oligophenylenes were observed at wavelengths as long as 366 nm, emission maxima to 437 nm, and molar extinction coefficients (ɛ) as large as 153,000 L/mol-cm; all three exceeded predicted maximum values for the corresponding unbridged oligophenylenes. The substitution of furan for benzene or carbazole for a fluorene (two examples each) bathochromically shifted absorption and emission maxima. Dialkylated carbon bridges bathochromically shifted absorption and emission maxima, and lowered Φf in biphenyl and in one terphenyl analogue, but appeared to cause no diminution of Φf in higher oligophenylenes. Bis(2-methoxyethyl) substitution on the bridges, incorporated to provide solubility in polar solvents, lowered Φf in all examples. Tertiary alkyl substituents on terminal rings bathochromically shifted the absorption and emission maxima and generally increased Φf. The "loose bolt" effect, which lowers Φf in mononuclear substituted benzenes, may operate in 9,9-dialkylfluorenes, but not in 2,7-di-t-butylfluorene or in higher oligophenylenes. Cyclic ether and methoxy substituents as auxofluors on terminal rings generally bathochromically shifted absorption and emission maxima and increased ɛ and Φf. Cyano substituents bathochromically shifted absorption and emission maxima, and increased ɛ, but lowered Φf slightly.

No abstract

The performance characteristics of a series of new excimer pumped ultraviolet dyes are presented. Chemical structure modifications which influence dye performance are discussed. An evaluation of several alternative solvents shows that p-dioxane remains the solvent of choice based on dye performance. The influence of the cover gas in the dye circulator was examined and results are presented to show how dye performance can greatly depend on this factor.