No abstract

No abstract

PurposeLaser milling is a recent process in mould making, providing several advantages over traditional mould making technologies by reducing manufacturing time, shortening the number of machining operations and avoiding expensive electrodes. This paper investigates the influence of the operating conditions on both the surface quality and material removal for two types of materials commonly used in mould making.Design/methodology/approachLaser scanning strategies and operating parameters like scanning speed and laser frequency and power were tested, regarding surface quality and material removal rate. The most representative parameter of the real surface quality, Rk, the core roughness parameter, is used to characterise the surface finishing on all cavities.FindingsThe findings of this research work suggest that it is possible to significantly reduce processing time by increasing the hatch spacing up to a value close to the laser beam spot diameter, without compromising surface quality. Lower pulse frequencies and laser power are more appropriate whenever surface quality is an issue. Higher material removal rates are achieved by increasing both the pulse frequency till an optimum value and laser power. The increase of scanning speed reduces the material removal rate by decreasing the overlap degree between individual laser pulses.Originality/valueThe originality is to correlate the influence of the operating conditions of laser milling on both the surface quality and material removal for different types of materials.

Microinjection has proven to be one of the most efficient replication methods for microcomponents and microsystems in various domains of microengineering. The use of available commercial microinjection equipment to evaluate the polymeric flow in microchannels would surely contribute to enhancing knowledge on polymeric flow at the microscale under industrial conditions. This approach is appropriate since rheological phenomena such as wall slip, surface tension, melt pressure drop and polymer flow length can be studied. These aspects are not fully dealt with in current commercial simulation software packages. In this study a micromould was designed to assess and characterize the flow in microchannels under realistic industrial conditions.