AimsIn the current study we investigated the effects of resisted sprint training on sprinting performance and underlying mechanical parameters (force-velocity-power profile) based on two different training protocols: (i) loads that represented maximum power output (Lopt) and a 50% decrease in maximum unresisted sprinting velocity and (ii) lighter loads that represented a 10% decrease in maximum unresisted sprinting velocity, as drawn from previous research (L10).MethodsSoccer [n = 15 male] and rugby [n = 21; 9 male and 12 female] club-level athletes were individually assessed for horizontal force-velocity and load-velocity profiles using a battery of resisted sprints, sled or robotic resistance respectively. Athletes then performed a 12-session resisted (10 × 20-m; and pre- post-profiling) sprint training intervention following the L10 or Lopt protocol.ResultsBoth L10 and Lopt training protocols had minor effects on sprinting performance (average of -1.4 to -2.3% split-times respectively), and provided trivial, small and unclear changes in mechanical sprinting parameters. Unexpectedly, Lopt impacted velocity dominant variables to a greater degree than L10 (trivial benefit in maximum velocity; small increase in slope of the force-velocity relationship), while L10 improved force and power dominant metrics (trivial benefit in maximal power; small benefit in maximal effectiveness of ground force orientation).ConclusionsBoth resisted-sprint training protocols were likely to improve performance after a short training intervention in already sprint trained athletes. However, widely varied individualised results indicated that adaptations may be dependent on pre-training force-velocity characteristics.

We tested the hypothesis that the degree of adaptation to highly focused sprint training at opposite ends of the sprint Force-Velocity (FV) spectrum would be associated with initial sprint FV profile in rugby athletes. Training-induced changes in sprint FV profiles were computed before and after an eight-week in-season resisted or assisted sprint training protocol, including a three-week taper. Professional male rugby players (age: 18.9 ± 1.0 years; body height: 1.9 ± 0.0 m; body mass: 88.3 ± 10.0 kg) were divided into two groups based on their initial sprint FV profiles: 1) Heavy sled training (RESISTED, N = 9, velocity loss 70–80%), and 2) assisted acceleration training (ASSISTED, N = 12, velocity increase 5–10%). A total of 16 athletes were able to finish all required measurements and sessions. According to the hypothesis, a significant correlation was found between initial sprint FV profile and relative change in sprint FV profile (RESISTED: r = −0.95, p < 0.01, ASSISTED: r = −0.79, p < 0.01). This study showed that initial FV properties influence the degree of mechanical response when training at different ends of the FV spectrum. Practitioners should consider utilizing the sprint FV profile to improve the individual effectiveness of resisted and assisted sprint training programs in high-level rugby athletes.