The Coupled Air–Sea Processes and Electromagnetic Ducting Research (CASPER) project aims to better quantify atmospheric effects on the propagation of radar and communication signals in the marine environment. Such effects are associated with vertical gradients of temperature and water vapor in the marine atmospheric surface layer (MASL) and in the capping inversion of the marine atmospheric boundary layer (MABL), as well as the horizontal variations of these vertical gradients. CASPER field measurements emphasized simultaneous characterization of electromagnetic (EM) wave propagation, the propagation environment, and the physical processes that gave rise to the measured refractivity conditions. CASPER modeling efforts utilized state-of-the-art large-eddy simulations (LESs) with a dynamically coupled MASL and phase-resolved ocean surface waves. CASPER-East was the first of two planned field campaigns, conducted in October and November 2015 offshore of Duck, North Carolina. This article highlights the scientific motivations and objectives of CASPER and provides an overview of the CASPER-East field campaign. The CASPER-East sampling strategy enabled us to obtain EM wave propagation loss as well as concurrent environmental refractive conditions along the propagation path. This article highlights the initial results from this sampling strategy showing the range-dependent propagation loss, the atmospheric and upper-oceanic variability along the propagation range, and the MASL thermodynamic profiles measured during CASPER-East.

No abstract

The height of the atmospheric boundary layer (ABL) is an important variable in both observational studies and model simulations. The most commonly used measurement for obtaining ABL height is a rawinsonde profile. Mesoscale or regional scale models use a bulk Richardson number based on profiles of the forecast variables. Here we evaluate the limitations of several frequently-used approaches for defining ABL height from a single profile, and identify the optimal threshold value for each method if profiles are the only available measurements. Aircraft measurements from five field projects are used, representing a variety of ABL conditions including stable, convective, and cloud-topped boundary layers over different underlying surfaces. ABL heights detected from these methods were validated against the 'true' value determined from aircraft soundings, where ABL height is defined as the top of the layer with significant turbulence. A detection rate was defined to denote how often the ABL height was correctly diagnosed with a particular method. The results suggest that the temperature gradient method provides the most reasonable estimates, although the detection rate and suitable detection criteria vary for different types of ABL. The Richardson number method, on the other hand, is in most cases inadequate or inferior to the other methods that were tried. The optimal range of the detection criteria is given for all ABL types examined in this study.

Urban areas often experience high precipitation rates and heights associated with flash flood events. Atmospheric and hydrological models in combination with remote-sensing and surface observations are used to analyze these phenomena. This study aims to conduct a hydrometeorological analysis of a flash flood event that took place in the sub-urban area of Mandra, western Attica, Greece, using remote-sensing observations and the Chemical Hydrological Atmospheric Ocean Wave System (CHAOS) modeling system that includes the Advanced Weather Research Forecasting (WRF-ARW) model and the hydrological model (WRF-Hydro). The flash flood was caused by a severe storm during the morning of 15 November 2017 around Mandra area resulting in extensive damages and 24 fatalities. The X-band dual-polarization (XPOL) weather radar of the National Observatory of Athens (NOA) observed precipitation rates reaching 140 mm/h in the core of the storm. CHAOS simulation unveils the persistent orographic convergence of humid southeasterly airflow over Pateras mountain as the dominant parameter for the evolution of the storm. WRF-Hydro simulated the flood using three different precipitation estimations as forcing data, obtained from the CHAOS simulation (CHAOS-hydro), the XPOL weather radar (XPOL-hydro) and the Global Precipitation Measurement (GMP)/Integrated Multi-satellitE Retrievals for GPM (IMERG) satellite dataset (GPM/IMERG-hydro). The findings indicate that GPM/IMERG-hydro underestimated the flood magnitude. On the other hand, XPOL-hydro simulation resulted to discharge about 115 m3/s and water level exceeding 3 m in Soures and Agia Aikaterini streams, which finally inundated. CHAOS-hydro estimated approximately the half water level and even lower discharge compared to XPOL-hydro simulation. Comparing site-detailed post-surveys of flood extent, XPOL-hydro is characterized by overestimation while CHAOS-hydro and GPM/IMERG-hydro present underestimation. However, CHAOS-hydro shows enough skill to simulate the flooded areas despite the forecast inaccuracies of numerical weather prediction. Overall, the simulation results demonstrate the potential benefit of using high-resolution observations from a X-band dual-polarization radar as an additional forcing component in model precipitation simulations.

Accurate estimation of precipitation at high spatial and temporal resolution of weather radars is an open problem in hydrometeorological applications. The use of dual polarization gives the advantage of multiparameter measurements using orthogonal polarization states. These measurements carry significant information, useful for estimating rain-path signal attenuation, drop size distribution (DSD), and rainfall rate. This study evaluates a new self-consistent with optimal parameterization attenuation correction and rain microphysics estimation algorithm (named SCOP-ME). Long-term X-band dual-polarization measurements and disdrometer DSD parameter data, acquired in Athens, Greece, have been used to quantitatively and qualitatively compare SCOP-ME retrievals of median volume diameter D 0 and intercept parameter N W with two existing rain microphysical estimation algorithms and the SCOP-ME retrievals of rain rate with three available radar rainfall estimation algorithms. Error statistics for rain rate estimation, in terms of relative mean and root-mean-square error and efficiency, show that the SCOP-ME has low relative error if compared to the other three methods, which systematically underestimate rainfall. The SCOP-ME rain microphysics algorithm also shows a lower relative error statistic when compared to the other two microphysical algorithms. However, measurement noise or other signal degradation effects can significantly affect the estimation of the DSD intercept parameter from the three different algorithms used in this study. Rainfall rate estimates with SCOP-ME mostly depend on the median volume diameter, which is estimated much more efficiently than the intercept parameter. Comparisons based on the long-term dataset are relatively insensitive to pathintegrated attenuation variability and rainfall rates, providing relatively accurate retrievals of the DSD parameters when compared to the other two algorithms.