Recent commercialization of auxin herbicide–based weed control systems has led to increased off-target exposure of susceptible cotton cultivars to auxin herbicides. Off-target deposition of dilute concentrations of auxin herbicides can occur on cotton at any stage of growth. Field experiments were conducted at two locations in Mississippi from 2014 to 2016 to assess the response of cotton at various growth stages after exposure to a sublethal 2,4-D concentration of 8.3 g ae ha−1. Herbicide applications occurred weekly from 0 to 14 weeks after emergence (WAE). Cotton exposure to 2,4-D at 2 to 9 WAE resulted in up to 64% visible injury, whereas 2,4-D exposure 5 to 6 WAE resulted in machine-harvested yield reductions of 18% to 21%. Cotton maturity was delayed after exposure 2 to 10 WAE, and height was increased from exposure 6 to 9 WAE due to decreased fruit set after exposure. Total hand-harvested yield was reduced from 2,4-D exposure 3, 5 to 8, and 13 WAE. Growth stage at time of exposure influenced the distribution of yield by node and position. Yield on lower and inner fruiting sites generally decreased from exposure, and yield partitioned to vegetative or aborted positions and upper fruiting sites increased. Reductions in gin turnout, micronaire, fiber length, fiber-length uniformity, and fiber elongation were observed after exposure at certain growth stages, but the overall effects on fiber properties were small. These results indicate that cotton is most sensitive to low concentrations of 2,4-D during late vegetative and squaring growth stages.

The introduction of auxin herbicide weed control systems has led to increased occurrence of crop injury in susceptible soybeans and cotton. Off-target exposure to sublethal concentrations of dicamba can occur at varying growth stages, which may affect crop response. Field experiments were conducted in Mississippi in 2014, 2015, and 2016 to characterize cotton response to a sublethal concentration of dicamba equivalent to 1/16X the labeled rate. Weekly applications of dicamba at 35 g ae ha−1were made to separate sets of replicated plots immediately following planting until 14 wk after emergence (WAE). Exposure to dicamba from 1 to 9 WAE resulted in up to 32% visible injury, and exposure from 7 to 10 WAE delayed crop maturity. Exposure from 8 to 10 and 13 WAE led to increased cotton height, while an 18% reduction in machine-harvested yield resulted from exposure at 6 WAE. Cotton exposure at 3 to 9 WAE reduced the seed cotton weight partitioned to position 1 fruiting sites, while exposure at 3 to 6 WAE also reduced yield in position 2 fruiting sites. Exposure at 2, 3, and 5 to 7 WAE increased the percent of yield partitioned to vegetative branches. An increase in percent of yield partitioned to plants with aborted terminals occurred following exposure from 3 to 7 WAE and corresponded with reciprocal decreases in yield partitioned to positional fruiting sites. Minimal effects were observed on fiber quality, except for decreases in fiber length uniformity resulting from exposure at 9 and 10 WAE.

A chloroacetamide herbicide by application timing factorial experiment was conducted in 2017 and 2018 in Mississippi to investigate chloroacetamide use in a dicamba-based Palmer amaranth management program in cotton production. Herbicides used were S-metolachlor or acetochlor, and application timings were preemergence, preemergence followed by (fb) early postemergence, preemergence fb late postemergence, early postemergence alone, late postemergence alone, and early postemergence fb late postemergence. Dicamba was included in all preemergence applications, and dicamba plus glyphosate was included with all postemergence applications. Differences in cotton and weed response due to chloroacetamide type were minimal, and cotton injury 14 d after LP application was less than 10% for all application timings. Late-season weed control was reduced up to 30 and 53% if chloroacetamide application occurred PRE or LP only, respectively. Late-season weed densities were minimized if multiple applications were used instead of a single application. Cotton height was reduced by up to 23% if a single application was made LP relative to other application timings. Chloroacetamide application at any timing except PRE alone minimized late season weed biomass. Yield was maximized by any treatment involving multiple applications or EP alone whereas applications PRE or LP alone resulted in up to 56 and 27% yield losses, respectively. While no yield loss was reported by delaying the first of sequential applications until EP, foregoing a PRE application is not advisable given the multiple factors that may delay timely POST applications such as inclement weather.

Distinguishing 2,4-D and dicamba herbicide formulations in cotton and soybean tissue is challenging in regulation of crop injury from these herbicides. Additionally, stewardship of 2,4-D and dicamba technologies is important to maximize their longevity and efficacy. Research was conducted to (1) characterize cotton and soybean response to various formulations of 2,4-D or dicamba with or without glyphosate, (2) develop a method for classifying these formulations in crop tissue, and (3) optimize use of chloroacetamide herbicides in dicamba systems for mitigation of selection pressure on dicamba. Formulations evaluated include dicamba diglycolamine (DGA), dimethylamine (DMA), N,N-Bis-(3-aminopropyl) methylamine (BAPMA), and DGA plus potassium acetate (KAc); and 2,4-D DMA, acid, isooctyl ester (ESTER), and choline. Weed management by the chloroacetamides s-metolachlor and acetochlor was evaluated with applications preemergence (PRE), early postemergence (EP), late postemergence (LP), PRE followed by (fb) EP, PRE fb LP, and EP fb LP. Cotton and soybean response differed by 2,4-D and dicamba formulation, and glyphosate presence. Cotton yield was reduced by 200 to 500 kg ha-1 following exposure to 2,4-D choline or DMA relative to acid or ESTER. Glyphosate presence led to a reduction in cotton and soybean yield of 377 and 572 kg ha-1, respectively. Exposure to dicamba DMA resulted in a 263 kg ha-1 reduction in soybean yield relative to dicamba DGA, and glyphosate presence reduced yield by 439 and 246 kg ha-1 in cotton and soybeans, respectively. Chemometric analyses generated models capable of up to 85% accuracy in identifying dicamba formulation in cotton and soybean tissue, and up to 80% accuracy in identifying 2,4-D formulation. Split chloroacetamide applications improved cotton yield up to 60%, reduced weed densities up to 90%, and improved control up to 56% relative to single applications. Cotton height was reduced up to 23% if a single chloroacetamide application was made. Soybean yield was maximized following any chloroacetamide application timing except PRE alone, and weed control was reduced up to 31% following single chloroacetamide application relative to split applications. These results will aid regulatory bodies in managing use of new weed control technologies and will assist producers in stewarding these new technologies.

Widespread use of glyphosate-resistant (GR) corn in rotation with cotton increases the incidence of volunteer GR corn in subsequent cotton stands. Experiments were conducted in Mississippi in 2011 and 2012 to determine cotton response to volunteer corn present at 0.3, 1.6, or 3.2 plants per m of crop row allowed to persist for zero, one, two, six, eight, 10 and 12 weeks after emergence or until cotton harvest. Cotton maturity was accelerated at a density of 3.2 plants per m of crop row. Neither cotton height nor yield was affected by corn removal timing at the low corn density. Cotton height and yield decreased as the time of corn removal was delayed at the medium and high corn densities. No differences in cotton height were observed from increasing corn density at removal timings up to two weeks after cotton emergence (WACE). At each corn removal timing four WACE and beyond, increasing corn density led to reductions in cotton height. No differences in cotton yield were observed from increasing density at corn removal timings zero or one WACE; increases in corn density at removal timings beyond one WACE generally led to reductions in cotton yield. These data indicate medium to high populations of volunteer corn generally should be removed by four to six WACE to prevent height reductions and yield loss.