Field experiments were conducted in Nebraska with the experimental herbicide KIH-485 on soils with three different levels of organic matter (OM) to ascertain a dose response for weed control and corn tolerance. Dose–response curves based on the log-logistic model were used to determine the effective dose that provides 90% weed control (ED90 values) for three grasses (green foxtail, field sandbur, large crabgrass) and two broadleaf weeds (velvetleaf, tall waterhemp). The ED90 values for green foxtail control were 143, 165, and 202 g ai/ha for soils with 1, 2, and 3% OM, respectively at 28 d after treatment (DAT). The highest dose of 371 g ai/ha was needed for field sandbur control at 28 DAT, compared with 141 g ai/ha for large crabgrass, 152 g ai/ha for tall waterhemp, and 199 g ai/ha for velvetleaf. There was no significant corn injury observed. Grain yield increased with increasing doses of KIH-485; optimum yield was achieved at about 195 g ai/ha. From the dose–response curves it is clear that the proposed label rate of KIH-485 of 200 to 300 g ai/ha will provide excellent control of most grasses and certain broadleaf weeds in corn for at least the first 4 wk of the growing season on soils up to 3% OM in the state of Nebraska.

Field and greenhouse experiments were conducted in Nebraska to (1) confirm the 4-hydroxyphenylpyruvate dioxygenase (HPPD)-inhibiting resistant-waterhemp biotype (HPPD-RW) by quantifying the resistance levels in dose-response studies, and (2) to evaluate efficacy of PRE-only, POST-only, and PRE followed by POST herbicide programs for control of HPPD-RW in corn. Greenhouse dose-response studies confirmed that the suspected waterhemp biotype in Nebraska has evolved resistance to HPPD-inhibiting herbicides with a 2-to 18-fold resistance depending upon the type of HPPD-inhibiting herbicide being sprayed. Under field conditions, at 56 d after treatment, ≥90% control of the HPPD-RW was achieved with PRE-applied mesotrione/atrazine/ S-metolachlor + acetochlor, pyroxasulfone (180 and 270 g ai ha −1 ), pyroxasulfone/fluthiacet-methyl/ atrazine, and pyroxasulfone + saflufenacil + atrazine. Among POST-only herbicide programs, glyphosate, a premix of mesotrione/atrazine tank-mixed with diflufenzopyr/dicamba, or metribuzin, or glufosinate provided ≥92% HPPD-RW control. Herbicide combinations of different effective sites of action in mixtures provided ≥86% HPPD-RW control in PRE followed by POST herbicide programs. It is concluded that the suspected waterhemp biotype is resistant to HPPD-inhibiting herbicides and alternative herbicide programs are available for effective control in corn. The occurrence of HPPD-RW in Nebraska is significant because it limits the effectiveness of HPPD-inhibiting herbicides. Nomenclature: Acetochlor, atrazine, glyphosate, clopyralid, dicamba, diflufenzopyr, dimethenamid-P, flumetsulam, fluthiacet-methyl, glufosinate, isoxaflutole, mesotrione, metribuzin, pyroxasulfone S-metolachlor, saflufenacil, rimsulfuron, tembotrione, thiencarbazone-methyl, topramezone, waterhemp, Amaranthus tuberculatus (Moq.) Sauer, corn, Zea mays L. Key words: 4-hydroxyphenylpyruvate dioxygenase, pigment inhibitors, PRE, POST, triketone, weed management, weed resistance. Se realizaron experimentos de campo y de invernadero en Nebraska para (1) confirmar un biotipo de Amaranthus tuberculatus resistente a inhibidores de 4-hydroxyphenylpyruvate dioxygenase (HPPD) (HPPD-RW) cuantificando el nivel de resistencia con estudios de respuesta a dosis, y (2) evaluar la eficacia de programas de herbicidas para el control de HPPD-RW en maíz con sólo herbicidas PRE, sólo POST, y herbicidas PRE seguidos por POST. Los estudios de respuesta a dosis en invernadero confirmaron que el biotipo de A. tuberculatus en Nebraska ha evolucionado resistencia a herbicidas inhibidores de HPPD con 2 a 18 veces mayor resistencia dependiendo del tipo de herbicida inhibidor de HPPD que se aplicó. Bajo condiciones de campo, a 56 d después del tratamiento, se alcanzó ≥90% de control de HPPD RW con aplicaciones PRE de mesotrione/ atrazine/S-metolachlor + acetochlor, pyroxasulfone (180 y 270 g ai ha), pyroxasulfone/fluthiacet-methyl/atrazine, y pyroxasulfone + saflufenacil + atrazine. Entre los programas de herbicidas con sólo POST, glyphosate, una premezcla d...

Core Ideas The impact of simulated dicamba drift on growth and yield of glyphosate‐resistant soybean was similar among dicamba formulations. The impact of dicamba drift on soybean could be influenced by moisture condition of the environmental field. Late vegetative or early flowering stage of soybean was the most sensitive growth stage to dicamba drift. New dicamba‐based herbicides such as Engenia (N,N‐bis‐(3‐aminopropyl) methylamine salt) and XtendiMax (diglycolamine salt) with VaporGrip technology were developed to reduce dicamba volatility and drift; however, there are claims that these products can still volatilize or drift. Field studies were conducted to evaluate glyphosate (N‐(phosphonomethyl)glycine))–resistant (GR) soybean response to micro‐rates (0, 1/1000, 1/500, 1/100, 1/50, and 1/10 of the label rate, 560 g a.e. ha−1) of the two new dicamba products compared with Clarity (diglycolamine salt) applied at three growth stages. The GR soybean [Glycine max (L.) Merr.] was equally impacted by the micro‐rates of all three products as measured by visual injury, height reduction, delayed physiological maturity, and yield reduction. The greatest visual injury (80%), plant height reduction (65%), maturity delay (22 d), and soybean yield loss (96%) was caused by 1/10 of the dicamba label rate when applied at V7/R1 soybean growth stage. In addition, estimation of effective dose for 5, 10, or 20% yield reduction suggested that V7/R1 was the most sensitive soybean growth stage to the three dicamba products. For example, 10% yield reduction occurred when 1.83 to 1.85 g a.e. ha−1 (∼1/300 of the label rate) of Engenia was applied at V2 or R2, whereas, a lower dose of 0.32 g a.e. ha−1 (1/1750 of the label rate) of Engenia caused the same level of yield reduction when applied at V7/R1. Similar doses were estimated for Clarity and XtendiMax; therefore dicamba drift should be avoided at all costs, because GR soybean was equally sensitive to low rates of all three tested products with different formulations or technologies.

Saflufenacil is a new herbicide being developed for preplant burndown and PRE broadleaf weed control in field crops, including corn, soybean, sorghum, and wheat. Field experiments were conducted in 2006 and 2007 at Concord, in northeast Nebraska, with the objective to describe dose–response curves of saflufenacil applied with several adjuvants for broadleaf weed control. Dose–response curves based on log-logistic model were used to determine the effective dose that provides 90% weed control (ED90) values for six broadleaf weeds (field bindweed, prickly lettuce, henbit, shepherd's-purse, dandelion, and field pennycress). Addition of adjuvants greatly improved efficacy of saflufenacil. For example, the ED90values for field bindweed control at 28 d after treatment were 71, 20, 11, and 7 g/ha for saflufenacil applied alone, or with nonionic surfactant (NIS), crop oil concentrate (COC), or methylated seed oil (MSO), respectively. MSO was the adjuvant that provided the greatest enhancement of saflufenacil across all species tested. COC was the second-best adjuvant and provided control similar to MSO on many weed species. NIS provided the least enhancement of saflufenacil. These results are very similar to the proposed label dose of saflufenacil for burndown weed control, which will range from 25 to 100 g/ha with MSO or COC. We believe that such a dose would provide excellent burndown control of most broadleaf weed species that emerge in the fall in Nebraska.

Although glyphosate controls many plant species, certain broadleaf weeds in Nebraska's cropping systems exhibit various levels of tolerance to the labeled rates of this herbicide, including ivyleaf morningglory, Venice mallow, yellow sweetclover, common lambsquarters, velvetleaf, kochia, Russian thistle, and field bindweed. Therefore, two field studies were conducted in 2004 and 2005 at Concord and North Platte, NE, to evaluate performance of (1) seven preemergence (PRE) herbicides and (2) glyphosate tank mixes applied postemergence (POST) at three application times for control of eight weed species that are perceived as problem weeds in glyphosate-resistant soybean in Nebraska. The PRE herbicides, including sulfentrazone plus chlorimuron, pendimethalin plus imazethapyr, imazaquin, and pendimethalin plus imazethapyr plus imazaquin provided more than 85% control of most weed species tested in this study 28 d after treatment (DAT). However, sulfentrazone plus chlorimuron and pendimethalin plus imazethapyr plus imazaquin were the only PRE treatments that provided more than 80% control of most weed species 60 DAT. In the POST glyphosate tank-mix study, the level of weed control was significantly affected by the timing of herbicide application; control generally decreased as weed height increased. In general, glyphosate tank mixes applied at the first two application times (early or mid-POST) with half label rates of lactofen, imazamox, imazethapyr, fomesafen, imazaquin, or acifluorfen, provided more than 80% control of all species that were 20 to 30 cm tall except ivyleaf morningglory, Venice mallow, yellow sweetclover, and field bindweed. Glyphosate tank mixes applied late POST with lactofen, imazethapyr, or imazaquin provided more than 70% control of common lambsquarters, velvetleaf, kochia, and Russian thistle that were 30 to 50 cm tall. Overall, glyphosate tank mixes with half label rates of chlorimuron or acifluorfen were the best treatments; they provided more than 80% control of all the studied weed species when applied at early growth stages. Results of this study suggested that mixing glyphosate with other POST broadleaf herbicides, or utilizing soil-applied herbicides after crop planting helped effectively control most problematic weeds in glyphosate-resistant soybean in Nebraska.