Antibacterial composite membranes of PCL/gelatin loaded with ZnO nanoparticles for guided tissue regeneration.

In the last years, important non-linear optical results on sol-gel and polymeric materials have been reported, with values comparable to those found in crystals. These new materials contain push-pull chromophores either incorporated as guest in a high T g polymeric matrix (doped polymers) or grafted onto the polymeric matrix. These systems present several advantages; however they require significant improvement at the molecular level -by designing optimized chromophores with very large molecular figure of merit, specific to each application targeted. Besides, it was recently stated in polymers that the chromophore-chromophore electrostatic interactions, which are dependent of chromophore concentration, have a strong effect into their non-linear optical properties. This has not been explored at all in sol-gel systems. In this work, the sol-gel route was used to prepare hybrid organic-inorganic thin films with different NLO chromophores grafted into the skeleton matrix. Combining a molecular engineering strategy for getting a larger molecular figure of merit and by controlling the intermolecular dipole-dipole interactions through both: the tuning of the push-pull chromophore concentration and the control of TEOS (Tetraethoxysilane) concentration, we have obtained a r 33 coefficient around 15 pm/V at 633 nm for the classical DR1 azo-chromophore and a r 33 around 50 pm/V at 831 nm for a new optimized chromophore structure. +: Work supported by DGAPA UNAM IN 103199, and CONACYT 34582-E. Reyes-Esqueda et al. "Effect of chromophore-chromophore electrostatic interactions in the NLO response of functionalized organic-inorganic sol-gel materials".

Blends of natural and synthetic polymers have recently attracted great attention as scaffolds for tissue engineering applications due to their favorable biological and mechanical properties. Nevertheless, phase-separation of blend components is an important challenge facing the development of electrospun homogeneous fibrillar natural-synthetic polymers scaffolds; phase-separation can produce significant detrimental effects for scaffolds fabricated by electrospinning. In the present study, blends of gelatin (Gel; natural polymer) and polycaprolactone (PCL; synthetic polymer), containing 30 and 45 wt% Gel, were prepared using acetic acid as a ‘green’ sole solvent to straightforwardly produce appropriate single-step Gel-PCL solutions for electrospinning. Miscibility of Gel and PCL in the scaffolds was assessed and the morphology, chemical composition and structural and solid-state properties of the scaffolds were thoroughly investigated. Results showed that the two polymers proved miscible under the single-step solution process used and that the electrospun scaffolds presented suitable properties for potential skin tissue engineering applications. Viability, metabolic activity and protein expression of human fibroblasts cultured on the Gel-PCL scaffolds were evaluated using LIVE/DEAD (calcein/ethidium homodimer), MTT-Formazan and immunocytochemistry assays, respectively. In vitro results showed that the electrospun Gel-PCL scaffolds enhanced cell viability and proliferation in comparison to PCL scaffolds. Furthermore, scaffolds allowed fibroblasts expression of extracellular matrix proteins, tropoelastin and collagen Type I, in a similar way to positive controls. Results indicated the feasibility of the single-step solution process used herein to obtain homogeneous electrospun Gel-PCL scaffolds with Gel content ≥30 wt% and potential properties to be used as scaffolds for skin tissue engineering applications for wound healing.

This work presents a study of commercial SiO2 optical fibre thermoluminescence (TL) properties as part of the efforts within the Dosimetric Application Project at the Physics Institute of the University of Mexico to develop new radiation detection materials and technologies. The SiO2 commercial optical fibre studied demonstrates useful TL properties and is an excellent candidate for use in TL dosimetry of ionising radiation. The optical fibre's glow curve was observed between 30 and 400 degrees C after exposure to 60Co gamma radiation. One very well-defined glow peak has a maximum at 230 degrees C. The TL response between 100 and 350 degrees C increases monotonically over a wide dose range, from 0.1 Gy to several kGy. It is linear in the range 0.1-3 Gy, which is important for clinical high dose or accident dosimetry. The optical fibre demonstrated high data reproducibility, low residual signal and almost no fading in our study. Moreover, the optical fibre can be re-used several times, after thermal annealing, without any detriment in the dose-response. All these TL characteristics, plus the small size of the 150 microm diameter SiO2 optical fibre, the high flexibility, easy handling and low cost compared with other TL materials, make the commercial optical fibre a very promising TL material for use in research, medicine, industry, reactors, and a variety of other applications.