Heavy metals still represent a group of dangerous pollutants, to which close attention is paid. Many heavy metals are essential as important constituents of pigments and enzymes, mainly zinc, nickel and copper. However, all metals, especially cadmium, lead, mercury and copper, are toxic at high concentration because of disrupting enzyme functions, replacing essential metals in pigments or producing reactive oxygen species. The toxicity of less common heavy metals and metalloids, such as thallium, arsenic, chromium, antimony, selenium and bismuth, has been investigated. Here, we review the phytotoxicity of thallium, chromium, antimony, selenium, bismuth, and other rare heavy metals and metalloids such as tellurium, germanium, gallium, scandium, gold, platinum group metals (palladium, platinum and rhodium), technetium, tungsten, uranium, thorium, and rare earth elements yttrium and lanthanum, and the 14 lanthanides cerium, dysprosium, erbium, europium, gadolinium, holmium, lutetium, neodymium, promethium, praseodymium, samarium, terbium, thulium and ytterbium.

The aim of this study was to describe behaviour, kinetics, time courses and limitations of the six different fully automated spectrometric methods - DPPH, TEAC, FRAP, DMPD, Free Radicals and Blue CrO5. Absorption curves were measured and absorbance maxima were found. All methods were calibrated using the standard compounds Trolox® and/or gallic acid. Calibration curves were determined (relative standard deviation was within the range from 1.5 to 2.5 %). The obtained characteristics were compared and discussed. Moreover, the data obtained were applied to optimize and to automate all mentioned protocols. Automatic analyzer allowed us to analyse simultaneously larger set of samples, to decrease the measurement time, to eliminate the errors and to provide data of higher quality in comparison to manual analysis. The total time of analysis for one sample was decreased to 10 min for all six methods. In contrary, the total time of manual spectrometric determination was approximately 120 min. The obtained data provided good correlations between studied methods (R = 0.97 – 0.99).

No abstract

Vitamin C (ascorbic acid, ascorbate, AA) is a water soluble organic compound that participates in many biological processes. The main aim of this paper was to utilize two electrochemical detectors (amperometric – Coulouchem III and coulometric – CoulArray) coupled with flow injection analysis for the detection of ascorbic acid. Primarily, we optimized the experimental conditions. The optimized conditions were as follows: detector potential 100 mV, temperature 25 °C, mobile phase 0.09% TFA:ACN, 3:97 (v/v) and flow rate 0.13 mL·min-1. The tangents of the calibration curves were 0.3788 for the coulometric method and 0.0136 for the amperometric one. The tangent of the calibration curve measured by the coulometric detector was almost 30 times higher than the tangent measured by the amperometric detector. Consequently, we coupled a CoulArray electrochemical detector with high performance liquid chromatography and estimated the detection limit for AA as 90 nM (450 fmol per 5 μL injection). The method was used for the determination of vitamin C in a pharmaceutical preparations (98 ± 2 mg per tablet), in oranges (Citrus aurantium) (varied from 30 to 56 mg/100 g fresh weight), in apples (Malus sp.) (varied from 11 to 19 mg/100 g fresh weight), and in human blood serum (varied from 38 to 78 μM). The recoveries were also determined.

Heavy metals represent a group of dangerous pollutants, to which is paid close attention. Many heavy metals are essential as important constituents of pigments and enzymes-mainly zinc, nickel, and copper. However, all metals, especially cadmium, lead, mercury, and copper, are toxic in high concentrations because they disrupt enzyme functions, replacing essential metals in pigments or producing reactive oxygen species. The toxicity of less common heavy metals and metalloids, such as thallium, arsenic, chromium, antimony, selenium, and bismuth has been investigated. Here we review the phytotoxicity of thallium, chromium, antimony, selenium, bismuth; and other rare heavy metals and metalloids such as