The structure of PIMT reveals a unique modification of the methyltransferase fold along with a site for specific recognition of isoaspartyl substrates. The sequence conservation among PIMTs suggests that the current structure should prove a reliable model for understanding the repair of isoaspartyl damage in all organisms.

No abstract

The inhibitor complex produced by the binding of alpha-D-glucose 1-phosphate 6-vanadate to the dephospho form of muscle phosphoglucomutase exhibits an unusually small dissociation constant: about 15 fM for the Mg2+ enzyme at pH 7.4, when calculated in terms of the tetraanion. Such tight binding suggests that the enzyme/vanadate/glucose phosphate complex mimics a state that at least approaches the transition state for (PO3-) transfer in the normal enzymic reaction. This hypothesis also is supported by the observation that replacement of Mg2+, the normal metal ion activator, by Li+, a poor activator, substantially reduces the binding constant for the glucose phosphate/vanadate mixed diester. Other indicators that support this hypothesis are described. One is the derived equilibrium constant for replacement of a PO4(2-) group in bound glucose bisphosphate by VO4(2-): 3 x 10(6) when the replaced group is the phosphate at the (PO3-) transfer site of the Mg2+ enzyme--in contrast to about 10 for the same replacement (of PO4(2-) by VO4(2-)) in an aqueous solution of a phosphate ester. Another is the greatly decreased rate at which Mg2+ dissociates from the glucose phosphate/vanadate complex of the enzyme, relative to the rate at which it dissociates from the corresponding bisphosphate complex (rate ratio less than or equal to 3 x 10(-4)), presumably because Mg2+ binds more tightly to the glucose phosphate/vanadate complex than to the corresponding bisphosphate complex. This apparent increase in Mg2+ binding occurs in spite of what appears to be a reduced charge density at the bound vanadate grouping, relative to the bound phosphate grouping, and in spite of the somewhat weaker binding of Mg2+ by dianionic vanadate than by the phosphate dianion. Although a direct assessment of the binding constant for Mg2+ was not possible, the equilibrium constant for Mg2+/Li+ exchange could be evaluated for the complexes of dephospho enzyme with glucose bisphosphate or glucose 1-phosphate 6-vanadate. The results suggest that the glucose phosphate/vanadate complex of the Mg2+ enzyme mimics a state about halfway between the ground state and the transition state for (PO3-) transfer. This estimate also is in accord with the binding of glucose phosphate/vanadate relative to that expected for transition-state binding of glucose bisphosphate. A possible scenario for the (PO3-) transfer catalyzed by the Mg2+ form of phosphoglucomutase is discussed, on the basis of these observations, together with possible reasons why the bound vanadate group appears to mimic an intermediate state for (PO3-) transfer rather than the ground state for phosphate binding.

A model procedure for removing salt from relatively fragile salt-induced protein crystals is proposed. The procedure is based on physical principles and is validated by using millimeter-size crystals of rabbit muscle phosphoglucomutase grown from a 2.1 M solution of ammonium sulfate. Three types of operations are included in the procedure: initial transfer to salt solutions of reduced concentration; transfer to the organic-rich phase of an equilibrium biphasic mixture obtained with aqueous solutions of polyoxyethylene and the salt; and addition of various replacement cosolutes in aqueous solutions of polyoxyethylene to reduce osmotic stress on the crystal as the remaining salt is removed. A critical feature of the overall procedure is maintenance of near equilibrium throughout by using a large number of steps involving small changes in solute concentration. The conditions used in the actual transfer were adjusted to eliminate the fracturing of crystals by visually distinguishing between two opposing types of fracture patterns: those produced by osmotic crushing as opposed to osmotic expansion. Basic requirements for a successful procedure with other protein crystals are a high permeability toward small solutes and a relatively slow dissolution rate at salt concentrations for which biphasic mixtures can be obtained. Desalted crystals of phosphoglucomutase have no visible fractures, are stable in the final solution for at least a week, and exhibit no noticeable change in the resolution of their X-ray diffraction pattern. In fact, desalted crystals can be rapidly cooled to 160 K, whereas untreated crystals are almost completely disordered by the same cooling procedure. The component of the desalting mixture whose presence is crucial to the success of the cooling process is polyoxyethylene, which apparently impedes the formation of ice within the protein crystal. Diffraction data obtained with an area-detector diffractometer did not differ significantly, either in terms of quality or resolution range, between crystals in 2.3 M ammonium sulfate at room temperature and crystals at 160 K in which ammonium sulfate had been replaced by glycine. The successful use of the following replacement solutes, instead of glycine, also is documented: sucrose, glycerol, and a low molecular weight poly(ethylene glycol) (PEG-400).

Net rate constants that define the steady-state rate through a sequence of steps and the corresponding effective energy barriers for two (PO3-)-transfer steps in the phosphoglucomutase reaction were compared as a function of metal ion, M, where M = Mg2+ and Cd2+. These steps involve the reaction of either the 1-phosphate or the 6-phosphate of glucose 1,6-bisphosphate (Glc-P2) bound to the dephosphoenzyme (ED) to produce the phosphoenzyme (EP) and the free monophosphates, glucose 1-phosphate (Glc-1-P) or glucose 6-phosphate (Glc-6-P): EP.M + Glc-1-P----ED.M.Glc-P2----EP.M.Glc-6-P6. Before this comparison was made, net rate constants for the Cd2+ enzyme, obtained at high enzyme concentration via 31P NMR saturation-transfer studies [Post, C. B., Ray, W. J., Jr., & Gorenstein, D. G. (1989) Biochemistry (preceding paper in this issue)], were appropriately scaled by using the observed constants to calculate both the expected isotope-transfer rate at equilibrium and the steady-state rate under initial velocity conditions and comparing the calculated values with those measured in dilute solution. For the Mg2+ enzyme, narrow limits on possible values of the corresponding net rate constants were imposed on the basis of initial velocity rate constants for the forward and reverse directions plus values for the equilibrium distribution of central complexes, since direct measurement is not feasible. The effective energy barriers for both the Mg2+ and Cd2+ enzymes, calculated from the respective net rate constants, together with previously values for the equilibrium distribution of complexes in both enzymic systems [Ray, W. J., Jr., & Long, J. W. (1976) Biochemistry 15, 4018-4025], show that the 100-fold decrease in the kappa cat for the Cd2+ relative to the Mg2+ enzyme is caused by two factors: the increased stability of the intermediate bisphosphate complex and the decreased ability to cope with the phosphate ester involving the 1-hydroxyl group of the glucose ring. In fact, it is unlikely that the efficiency of (PO3-) transfer to the 6-hydroxyl group of bound Glc-1-P (thermodynamically favorable direction) is reduced by more than an order of magnitude in the Cd2+ enzyme. By contrast, the efficiency of the Li+ enzyme in the same (PO3-)-transfer step is less than 4 x 10(-8) that of the Mg2+ enzyme.(ABSTRACT TRUNCATED AT 400 WORDS)