The mechanical properties of cellulose-based electro-active paper (EAPap) are investigated under various environmental conditions. Cellulose EAPap has been discovered as a smart material that can be used as both sensor and actuator. Its advantages include low voltage operation, light weight, low power consumption, biodegradability and low cost. EAPap is made with cellulose paper coated with thin electrodes. EAPap shows a reversible and reproducible bending movement as well as longitudinal displacement under an electric field. However, EAPap is a complex anisotropic material which has not been fully characterized. This study investigates the mechanical properties of cellulose-based EAPap, including Young's modulus, yield strength, ultimate strength and creep, along with orientation directions, humidity and temperature levels. To test the materials in different humidity and temperature levels, a special material testing system was made that can control the testing environmental conditions. The initial Young's modulus of EAPap is in the range of 4-9 GPa, which was higher than that of other polymer materials. Also, the Young's modulus is orientation dependent, which may be associated with the piezoelectricity of EAPap materials. The elastic strength and stiffness gradually decreased when the humidity and temperature were increased. Creep and relaxation were observed under constant stress and strain, respectively. Through scanning electron microscopy, EAPap is shown to exhibit both layered and oriented cellulose macromolecular structures that impact both the elastic and plastic behavior.

Over the years, the Weather Research and Forecasting Model (WRF) has been gaining popularity as a low-cost alternative source of data for wind resource assessments. This paper investigates the impact of selected time control, and nudging options on wind simulations in WRF. We conducted 15 numerical experiments, combining 5 simulation run-times and 3 options for disabling nudging in the Planetary Boundary Layer (PBL) in WRF. Hourly wind speed and direction predictions were compared with actual measurements at 40 m, 50 m and 60 m a.g.l. From our results, we recommend that, for optimum performance, the method of disabling nudging in the PBL should be chosen with simulation run times in mind. For wind simulations in our study area, up to 2 days run-times with nudging disabled below 1600 m in model configurations gives the best wind speed predictions. However, disabling nudging below the model-calculated PBL height offers more consistent results and produces relatively less prediction error with longer run times.

No abstract

No abstract

Ghana produces over 50% of its electrical energy demands from fossil-fuelled thermal plants. To increase the proportion of renewable energy in the national energy generation, a Renewable Energy Master Plan (REMP) which seeks, among others, to shift the country's national energy generation capacity towards more renewable energy sources has been developed. The REMP noted that inadequate data on renewable energy sources such as wind is one of the challenges to achieving this target. In this regard, this paper assessed the open-source Weather Research and Forecasting Model, as a tool for generating wind resource data. The WRF model is often used to downscale meteorological datasets for wind resources assessments. However, due to diverse model options, performance assessments are required to establish the accuracy and suitability of a model configuration for an application in an area. This paper assessed the performance of a Weather Research and Forecasting Model configuration that is based on previous verification studies. In evaluation, data accuracy benchmarks were generally met by the downscaled wind data. A wind map that was generated was observed to be generally accurate and better than the previous 2001 wind map for Ghana. It is presumed that the configuration is suitable for wind mapping activities for the coastal areas in Ghana, and probably neighbouring countries. However, for downscaling time-series data, further studies are recommended.