The aim of this paper is to look closer at the rheological properties of plastics and their impact on technology in the plastics processing industry. The paper focuses on the influence of viscosity of the material on filling the mould cavity. Four materials were tested with the settings of process parameters with different viscosity. Using simulation software of Moldex3D, we can see the effect of change in viscosity in the material to be filled.
Study describes principles of diesel effect creation during thermoplastic injection
KEY WORDS
Diesel effect, burning marks, venting of injection moulds
Cold tube drawing provides higher accuracy compared to hot approaches. The process can be used to reduce the dimensions of tubes, and depending on the reduction size, the wall thickness of these may be subject to changes. In the process, any form of variability provoked by external factors is highly sensitive, given that the resulting tubes are often the final step in tube production. This paper focused on the evaluation of the influence of pre-tube factors on key variables after the drawing process, i.e., the final roundness, outer diameter, and wall thickness of the tubes. For these purposes, a factorial design with fixed factors was implemented. It was also a goal to investigate if the single-pass type of drawing would guarantee good statistical results potentially leading to significant time and financial reductions. The measurements were executed in the machine ZEISS CenterMax. The statistical analysis took place on Minitab 19. The results prove that most factors, and their interactions, significantly impacted the response variables, leading the authors to understand that a single-pass approach would not properly work under the conditions defined for the experimentation. These results also allow for reflection on the causes and necessary measures related to lubrication, technological heritage, and quality that would impact the results themselves.
Particle Filled Polyethylene Composites Used in the Technology of Rotational Moulding
The submitted article discusses rotational moulding technology and filled plastics. For testing, linear low density polyethylene filled with talc was used. The materials tested varied way of mixing the filler into the polymer. For the prepared samples were evaluated by tensile, elongation, melt flow index, density, Shore hardness and Vicat softening temperature. Experiments showed that, in principle, it is possible to produce rotational moulding technology filled thermoplastics.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.