A new system that resolves the stratosphere was implemented for operational medium-range weather forecasts at the Canadian Meteorological Centre. The model lid was raised from 10 to 0.1 hPa, parameterization schemes for nonorographic gravity wave tendencies and methane oxidation were introduced, and a new radiation scheme was implemented. Because of the higher lid height of 0.1 hPa, new measurements between 10 and 0.1 hPa were also added. This new high-top system resulted not only in dramatically improved forecasts of the stratosphere, but also in large improvements in medium-range tropospheric forecast skill. Pairs of assimilation experiments reveal that most of the stratospheric and tropospheric forecast improvement is obtained without the extra observations in the upper stratosphere. However, these observations further improve forecasts in the winter hemisphere but not in the summer hemisphere. Pairs of forecast experiments were run in which initial conditions were the same for each experiment but the forecast model differed. The large improvements in stratospheric forecast skill are found to be due to the higher lid height of the new model. The new radiation scheme helps to improve tropospheric forecasts. However, the degree of improvement seen in tropospheric forecast skill could not be entirely explained with these purely forecast experiments. It is hypothesized that the cycling of a better model and assimilation provide improved initial conditions, which result in improved forecasts.

The modifications to the data assimilation component of the Regional Deterministic Prediction System (RDPS) implemented at Environment Canada operations during the fall of 2014 are described. The main change is the replacement of the limited-area four-dimensional variational data assimilation (4DVar) algorithm for the limited-area analysis and the associated three-dimensional variational data assimilation (3DVar) scheme for the synchronous global driver analysis by the four-dimensional ensemble–variational data assimilation (4DEnVar) scheme presented in the first part of this study. It is shown that a 4DEnVar scheme using global background-error covariances can provide RDPS forecasts that are slightly improved compared to the previous operational approach, particularly during the first 24 h of the forecasts and in the summertime convective regime. Further forecast improvements were also made possible by upgrades in the assimilated observational data and by introducing the improved global analysis presented in the first part of this study in the RDPS intermittent cycling strategy. The computational savings brought by the 4DEnVar approach are also discussed.

This paper describes the implementation of the 3D variational (3D-var) analysis in the Regional Data Assimilation System (RDAS) of the Canadian Meteorological Centre. The RDAS, a 12-h data assimilation cycle, is run twice daily to provide analyses to the variable resolution Global Environmental Multi-scale (GEM)

The European Space Agency Aeolus mission was launched in August 2018. This satellite carries the first Doppler lidar able to provide global measurements of wind profiles. Aeolus Level‐2B products have been generated and monitored by the European Centre for Medium‐Range Weather Forecasts (ECMWF) in near real‐time since a few weeks after the launch. These products include the horizontal line‐of‐sight (HLOS) winds that are suitable for data assimilation in numerical weather prediction systems. This article presents a series of observing system experiments conducted over summer 2019 to assess the value of the Level‐2B HLOS winds and their impact on the Environment and Climate Change Canada global forecasts. The impact of atmospheric motion vectors (AMVs) on forecasts is also examined and compared with the impact of HLOS winds. Two datasets are used: the HLOS winds produced in near real‐time at ECMWF and those reprocessed later in fall 2020. It is found that the near real‐time data are significantly biased and should be corrected. A look‐up table bias correction based on observation minus background departures is applied to this dataset as initially proposed by ECMWF. The reprocessed data are of better quality and bias corrected using the telescope's primary mirror temperature variations as predictor. The impacts of the near real‐time and reprocessed HLOS winds on forecasts are generally positive for both temperature and wind. The impacts are largest in the troposphere over the Tropics and polar regions. The positive impacts on forecasts are larger with the reprocessed data, particularly in the stratosphere, where a significant degradation over the Southern Hemisphere is found from assimilating the near real‐time data. The normalized forecast error reductions at days 1 and 2 for the wind are ∼1.25% over the Tropics and Southern Hemisphere. The positive impact of the HLOS winds on forecasts is enhanced by ∼40% when the AMVs are not assimilated in the control experiment. The forecast error reduction from assimilating AMVs is, however, two times larger than from assimilating HLOS winds in the extratropics. Conversely, the impact of HLOS winds on forecasts is generally larger in the Tropics.

Real-time horizontal wind observations from the National Oceanic and Atmospheric Administration's (NOAA's) Profiler Network (NPN) are assessed in preparation for their assimilation in the Canadian Meteorological Centre (CMC) analysis systems. As a first step, radiosonde winds from 20 stations were compared to the central U.S. profiler stations over the 2001/02 winter season. It was found that profilers are at least as good as conventional radiosonde data. The 2001/02 winter season data were also used to examine the vertical correlation structure of the observation error for profilers. Using a statistical analysis of innovations, the observation error standard deviation of the wind components is estimated as 2.2 m s Ϫ1 and the vertical correlation length is approximately 500 m. These results suggest that the data are vertically correlated because they are available every 250 m. Therefore, a thinning process is proposed in which one out of three data are selected in the vertical for each station.