A common phenomenon of organic solar cells (OSCs) incorporating metal‐oxide electron extraction layers is the requirement to expose the devices to UV light in order to improve device characteristics – known as the so‐called “light‐soaking” issue. This behaviour appears to be of general validity for various metal‐oxide layers, various organic donor/acceptor systems, and regardless if single junction devices or multi stacked cells are considered. The requirement of UV exposure of OSCs may impose severe problems if substrates with limited UV transmission, UV blocking filters or UV to VIS down‐conversion concepts are applied. In this paper, we will demonstrate that this issue can be overcome by the use of Al doped ZnO (AZO) as electron extraction interlayer. In contrast to devices based on TiOx and ZnO, the AZO devices show well‐behaved solar cell characteristics with a high fill factor (FF) and power conversion efficiency (PCE) even without the UV spectral components of the AM1.5 solar spectrum. As opposed to previous claims, our results indicate that the origin of s‐shaped characteristics of the OSCs is the metal‐oxide/organic interface. The electronic structures of the TiOx/fullerene and AZO/fullerene interfaces are studied by photoelectron spectroscopy, revealing an electron extraction barrier for the TiOx/fullerene case and facilitated electron extraction for AZO/fullerene. These results are of general relevance for organic solar cells based on various donor acceptor active systems.

No abstract

The development of multivalent metal (such as Mg and Ca) based battery systems is hindered by lack of suitable cathode chemistry that shows reversible multi‐electron redox reactions. Cationic redox centres in the classical cathodes can only afford stepwise single‐electron transfer, which are not ideal for multivalent‐ion storage. The charge imbalance during multivalent ion insertion might lead to an additional kinetic barrier for ion mobility. Therefore, multivalent battery cathodes only exhibit slope‐like voltage profiles with insertion/extraction redox of less than one electron. Taking VS 4 as a model material, reversible two‐electron redox with cationic–anionic contributions is verified in both rechargeable Mg batteries (RMBs) and rechargeable Ca batteries (RCBs). The corresponding cells exhibit high capacities of >300 mAh g −1 at a current density of 100 mA g −1 in both RMBs and RCBs, resulting in a high energy density of >300 Wh kg −1 for RMBs and >500 Wh kg −1 for RCBs. Mechanistic studies reveal a unique redox activity mainly at anionic sulfides moieties and fast Mg 2+ ion diffusion kinetics enabled by the soft structure and flexible electron configuration of VS 4 .

The buried interface between the bulk electrode material and the solid electrolyte interphase (SEI) in cycled Li-ion battery anodes is suggested to incorporate an electric potential gradient. This suggestion is based on photoelectron spectroscopy (PES) results from different anode materials that all show relative binding energy shifts between the components of the SEI and the active anode. Implications of this electric potential gradient on binding energy reference points in PES as well as on charge-transfer kinetics in Li-ion batteries are discussed. Specifically, we show that the separation of surface layer and bulk material spectral contributions (depth profiling) is crucial for consistent data interpretation. We conclude that previous interpretations of lithiation as cause for changes in PES spectra may need to be revised.