Silicon anode suffers from rapid capacity decay because of its irreversible volume changes during charging and discharging. As one of the important components of the electrode structure, the binder plays an irreplaceable role in buffering the volume changes of the silicon anode and ensuring close contact between various components of the electrode. Traditional PVDF binder is based on weak van der Waals forces and cannot effectively buffer the stress coming from silicon volume expansion, resulting in rapid decay of silicon anode capacity. In addition, most natural polysaccharide binders with a single force face the same problem due to poor toughness. Therefore, it is extremely important to develop a binder with good force and toughness between the silicon particles. Herein, polyacrylamide (PAM) polymer chains that are premixed homogeneously with various components are cross-linked on-site on the current collector via the condensation reaction with citric acid, forming a polar three-dimensional (3D) network with improved tensile properties and adhesion for both silicon particles and current collector. The silicon anode with the cross-linked PAM binder exhibits higher reversible capacity and enhanced long-term cycling stability; the capacity remains at 1280 mA h g–1 after 600 cycles at 2.1 A g–1 and 770.9 mA h g–1 after being subjected to 700 cycles at 4.2 A g–1. It also exhibits excellent cycle stability in silicon–carbon composite materials. This study provides a cost-effective binder engineering strategy, which significantly enhances the long-term cycle performance and stability of silicon anodes, paving the way for large-scale practical applications.

A Ni-rich layered oxide, one promising cathode for lithium-ion batteries (LIBs), exhibits the advantages of low cost and high capacity but suffers from rapid capacity loss due to bulk structural instability and surface side reactions. Herein, a simple synchronous dual-modification strategy with Zr4+ doping and CeO2 nanowelding is proposed to address such issues. Utilizing the migration energy difference of Zr and Ce ions in layered structures, one-step high-temperature sintering of LiNi0.8Co0.1Mn0.1O2 particles with Zr and Ce nitrate distributions enables simultaneous doping of Zr ions in the bulk and CeO2 surface modification. Therein, Zr ions in the bulk occupying the Li sites can improve the Li+ diffusion rate and stabilize the crystal structure, while CeO2 on the surface provides nanowelding between the grain boundaries and resistance to electrolyte erosion. Theoretical calculations and a series of structure/composition characterizations (i.e., neutron scattering, in situ X-ray diffraction, etc.) validated the proposed strategy and its role in stabilizing the Ni-rich cathodes. The synergistic effect of Zr4+ doping and CeO2 nanowelding enables an impressive initial capacity of 187.2 mAh g–1 (2.7–4.3 V vs Li/Li+) with 86.1% retention after 200 cycles at 1 C and rate capabilities of 146.6 and 127.3 mAh g–1 at 5 and 10 C, respectively. Upon increasing the testing temperature to 60 °C, the dual-modified Ni-rich cathode exhibits an initial discharge capacity of 203.5 mAh g–1 with a good retention of 80.8% after 100 cycles at 0.5 C. The present strategy utilizing the migration energy difference of metal ions to achieve synchronous bulk doping and surface modification will offer fresh insights to stabilize layered cathode materials for LIBs, which can be widely used in other kinds of batteries with various cathode materials.

No abstract