No abstract

Styrene–butadiene–styrene (SBS) polymer is extensively employed for asphalt pavement construction, and its degradation significantly damages the durability of asphalt concrete. However, the effect of aging protocols on the degradation of SBS polymer in asphalt binder has not been thoroughly investigated. In this study, confocal laser scanning microscopy (CLSM) was applied to characterize the change in morphology with SBS polymer degradation. Various aging protocols were considered, including accelerated aging processes in laboratory- and field-aged samples from three highway sections with different in-service periods. Scanned images of the polymer phase in the 2D plane at different depths were processed and further reconstructed in three dimensions. Furthermore, the three-dimensional polymer morphology indices derived from the semi-quantitative analysis of the images were correlated with the rheological indices. The results show that the polymer particles change from a relatively large ellipsoidal shape to a relatively small spherical shape as aging proceeds. The increase in aging temperature appears to accelerate the degradation of the polymer at the same rheological level. The effect of the laboratory aging method on the polymer was more pronounced during the early stages of aging compared to that in the field aging process.

The strength growth of a bitumen emulsion-based cold in-place recycling asphalt mixture (BE-CIR) is time-dependent and time-consuming due to the addition of water. There is a great difference between the curing conditions of specification in the laboratory and the in situ conditions, which often leads to a great discrepancy between the results of lab specimens and the field cores. The main objective of this paper is to evaluate the curing effect on laboratory BE-CIR considering field-water evaporation and heat-transfer conditions. Four different curing methods were designed by using different combinations of waterproof layers, heat insulation layers, and variable temperature modes. The variations in temperature indexes, moisture content, air void, and indirect tensile strength (ITS) with curing time were tested, and the mutual influence of these indicators was analyzed. Furthermore, the results of the laboratory samples were compared with the field cores. Testing results show that the performance of the BE-CIR mixture is significantly different from that with no treatment, which is manifested as higher moisture content and lower air void and ITS under the same curing time. The internal temperature of the mixture is the main factor affecting the variation of moisture content, especially on the first curing day. The air void of the mixture has a strong linear relationship with the moisture content. Moisture content and ITS under different curing methods showed similar trends and could be divided into two stages. Taking the field cores as a benchmark, it can be concluded that the field-water evaporation condition should be considered in the setting of indoor curing methods, while the heat transfer could not.

Four kinds of cold recycling (CR) mixtures with different asphalt emulsions were studied for their high-temperature performance in both binder properties and internal structures aspects. Digital image processing was introduced to determine the thickness spectrum for the asphalt mortar of the CR mixtures from a mesoscopic perspective. The time–temperature sweep (TTS) test was conducted to obtain the rheological parameters of each corresponding emulsified residue and the permanent deformation performance of each CR mixture was measured by dynamic creep test. A principle component analysis (PCA) was used to compare the typical performance parameters of the CR mixtures and find the factors controlling the rutting resistance of CR mixtures. The results show that the high-temperature performance of the CR mixtures with a modified emulsified asphalt showed improvements relative to the nominal case. Including Marshall stability, several parameters from the rheological properties of binder (G*/sinδ, flow number) and mortar thickness (max, range proportion 0–10 mm) could significantly influence the high-temperature performance and rutting resistance of the CR mixtures.