In response to the biopharmaceutical industry advancing from traditional batch operation to continuous operation, the Food and Drug Administration (FDA) has published a draft for continuous integrated biomanufacturing. This draft outlines the most important rules for establishing continuous integration. One of these rules is a thorough understanding of mass flows in the process. A computer simulation framework is developed for modeling the residence time distribution (RTD) of integrated continuous downstream processes based on a unit‐by‐unit modeling approach in which unit operations are simulated one‐by‐one across the entire processing time, and then combined into an integrated RTD model. The framework allows for easy addition or replacement of new unit operations, as well as quick adjustment of process parameters during evaluation of the RTD model. With this RTD model, the start‐up phase to reach steady state can be accelerated, the effects of process disturbances at any stage of the process can be calculated, and virtual tracking of a section of the inlet material throughout the process is possible. A hypothetical biomanufacturing process for an antibody was chosen for showcasing the RTD modeling approach.

Continuous virus inactivation (VI) has received little attention in the efforts to realize fully continuous biomanufacturing in the future. Implementation of continuous VI must assure a specific minimum incubation time, typically 60 min. To guarantee the minimum incubation time, we implemented a packed bed continuous viral inactivation reactor (CVIR) with narrow residence time distribution (RTD) for low pH incubation. We show that the RTD does not broaden significantly over a wide range of linear flow velocities—which highlights the flexibility and robustness of the design. Prolonged exposure to acidic pH has no impact on bed stability, assuring constant RTD throughout long term operation. The suitability of the packed bed CVIR for low pH inactivation is shown with two industry‐standard model viruses, that is xenotropic murine leukemia virus and pseudorabies virus. Controls at neutral pH showed no system‐induced VI. At low pH, significant VI is observed, even after only 15 min. Based on the low pH inactivation kinetics, the continuous process is equivalent to traditional batch operation. This study establishes a concept for continuous low pH inactivation and, together with previous reports, highlights the versatility of the packed bed reactor for continuous VI, regardless of the inactivation method.

Continuous virus inactivation (VI) remains one of the missing pieces while the biopharma industry moves toward continuous manufacturing. The challenges of adapting VI to the continuous operation are two‐fold: 1) achieving fluid homogeneity and 2) a narrow residence time distribution (RTD) for fluid incubation. To address these challenges, a dynamic active in‐line mixer and a packed‐bed continuous virus inactivation reactor (CVIR) are implemented, which act as a narrow RTD incubation chamber. The developed concept is applied using solvent/detergent (S/D) treatment for inactivation of two commonly used model viruses. The in‐line mixer is characterized and enables mixing of the viscous S/D chemicals to ±1.0% of the target concentration in a small dead volume. The reactor's RTD is characterized and additional control experiments confirm that the VI is due to the S/D action and not induced by system components. The CVIR setup achieves steady state rapidly before two reactor volumes and the logarithmic reduction values of the continuous inactivation process are identical to those obtained by the traditional batch operation. The packed‐bed reactor for continuous VI unites fully continuous processing with very low‐pressure drop and scalability.