Elsevier Vernet, N.; Ruiz, E.; Advani, S.; Alms, JB.; Aubert, M.; Barburski, M.; Barari, B.... (2014) Abstract:In this second international permeability benchmark, the in-plane permeability values of a carbon fabric were determined by 12 participants worldwide. One other participant also investigated the deformation of this fabric. The aim of this work was to obtain comparable results in order to make a step towards standardization of permeability measurements of fibrous reinforcements. The procedures used by most participants were according to the guidelines defined for this exercise after the first benchmark. Unidirectional injections in three in-plane directions of the fabric were conducted to determine the unsaturated in-plane permeability tensor. Parameters such as fiber volume fraction, injection pressure and fluid viscosity have been fixed in order to minimize sources of scatter. The comparison of the results from each participant was encouraging. The scatter between data obtained while respecting the test guidelines was close to the scatter of the setups themselves. A slightly 2 higher dispersion was observed when some parameters differed from the recommendations.Overall, a good correlation is observed between all the results of this exercise.

In this study, different weight fractions of multiwalled carbon nanotubes were dispersed in epoxy to produce toughened adhesives. The reinforced adhesives were used to bond the graphite fibre/epoxy composite adherends. Single lap joint samples were prepared and the average shear strengths were experimentally measured. Significant enhancement of the bonding performance was observed as the weight fraction of carbon nanotubes was increased.

No abstract

No abstract

No abstract