Although additive manufacturing (AM) has gained significant attention due to the advantages it offers and is currently a focus of much research, design of critical load carrying components utilizing such processes is still at its infancy. This is due to the fact that most of the load carrying components made by AM processes are subjected to cyclic loads, and fatigue behaviour of AM metals is far less understood as compared with those made by conventional methods, such as wrought and cast metals. To better understand the fatigue behaviour of AM metals, a wide range of issues that affect the behaviour in a synergistic manner must be considered. These include the effects of defects, residual stresses, surface finish, geometry and size, layer orientation, and heat treatment. Additionally, due to the multiaxial nature of the loading and/or complex geometries typically manufactured by AM processes, the stress state is often multiaxial including both normal and shear stresses. In this paper, the aforementioned effects influencing the fatigue resistance of AM parts, including torsion and multiaxial fatigue behaviour, are briefly discussed using some recently generated experimental data on Ti‐6Al‐4V by the authors.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.