Biovolatilisation of arsenic as their arsines in the form of AsH(3), and mono-, di and trimethylarsine has often been determined under laboratory conditions. Although environmental point sources such as landfill sites or hot springs have been characterised, only limited knowledge is available on how widespread the formation of volatile methylated arsenic compounds are in the environment. Here we studied the atmospheric stability of the different arsines and quantified their oxidation products in atmospheric particulate matter (PM(10)) in two locations in Argentina. The atmospheric half-life of the arsines range from 19 weeks for AsH(3) to 2 d for trimethylarsine (TMAs) at 20 degrees C in the dark, while during simulated daytime conditions the stability is reduced for all arsines and in particular for the methylated arsines by three orders of magnitude which suggests that TMAs can only be dispersed at night. At both locations the arsenic concentration was in all samples below 1 ng As m(-3), which is considered as rural background for arsenic. The oxidation products, i.e. methylarsonate (MA), dimethylarsinate (DMA) and trimethylarsine oxide (TMAO) were identified by using HPLC-ICP-MS/ES-MS in more than 90% of the 49 PM(10) samples taken from 8 sampling points at the two geographically different locations. TMAO was the predominate organoarsenicals in both locations (66 and 69%, respectively) while DMA was determined to be between 13 and 19% of all organoarsenicals at the two locations. The concentration of the organoarsenicals ranged from 4 to 60 pg As as TMAO m(-3), while the maximum concentration for DMA and MA were 16 and 6 pg As m(-3), respectively. No difference in terms of the concentration or distribution of the organoarsenicals in the PM(10) samples was identified as significant. Since the two locations were different in climate and industrial impact and sampled in different seasons, these data suggest that methylated arsenicals do occur as background chemicals in the environment. Due to the low atmospheric stability of the methylated arsines, it is suggested that biovolatilization of arsenic as methylated arsines is a widespread phenomenon. More studies however are necessary to identify the major sources and determine the flux of the volatilization process in order to determine whether or not the process has environmental significance.

The sampling of volatile metal(loid) compounds (VOMs) such as hydrides, methylated, and permethylated species of arsenic, antimony, and tin is described using Tedlar bags. Advantages as well as limitations and constraints are discussed and compared to other widely used sampling techniques within this area, namely, stainless steel canisters, cryotrapping, and solid adsorbent cartridges. To prove the suitability of Tedlar bags for the sampling of volatile metal(loid) compounds, series of stability tests have been run using both laboratory synthetic and real samples analyzed periodically after increasing periods of storage. The samples have been stored in the dark at 20 degrees C and at 50 degrees C. Various volatile arsenic species (AsH3, MeAsH2, Me2AsH, Me3As), tin species (SnH4, MeSnH3, Me2SnH2, Me3SnH, Me4Sn, BuSnH3), and antimony species (SbH3, MeSbH2, Me2SbH, Me3Sb) have been generated using hydride generation methodology and mixed with moisturized air. Three static gaseous atmospheres with concentrations of 0.3-18 ng/L for the various compounds have been generated in Tedlar bags, and the stability of the VOMs has been monitored over a period of 5 weeks. Sewage sludge digester gas samples have been stored only at 20 degrees C for a period of 48 h. Cryotrapping GC/ICPMS has been used for the determination of the VOMs with a relative standard deviation of 5% for 100 pg. After 8 h, the recovery rate of all the compounds in the air atmospheres was better than 95% at 20 and 50 degrees C, whereas the recovery after 24 h was found to be between 81 and 99% for all VOMs at 20 and 50 degrees C except for Me3Sb and Me3As. These species show a loss between 48 and 73% at both temperatures. After 5 weeks at 20 degrees C, a loss of only 25-50% for arsine and stibine and the above-mentioned tin compounds was determined. Only Me3Sb, Me3Bi, and Me2Te were present in the digester gas sample. After 24 h, losses of 44, 10, and 12%, respectively, could be determined. Given these results, Tedlar bags could even be used, with some limitations, for long-term sampling of air containing traces of VOMs. The loss is more pronounced at higher temperatures.

No abstract

The analytical performance of an axial inductively-coupled-plasma time-of-flight mass spectrometer (ICP-TOFMS) as a detector for fast transient chromatographic signals resulting from the coupling to capillary gas chromatography (CGC) was investigated. A cryotrapping GC-ICP-TOFMS method for the determination of volatile metal(loid) compounds (VOMs) in gases was used and the suitability of the TOF mass analyzer for multielemental speciation analysis and multi-isotope ratio determinations was studied in terms of accuracy and precision. Isotope ratios 118Sn/120Sn and 121Sb/123Sb have been determined in in-house gas standard atmospheres in Tedlar bags at two different levels (100 pg and 1 ng) for different elemental species (SnH4, MeSnH3, Me2SnH2, Me3SnH, BuSnH3, SbH3, and MeSbH2). A limitation arising from counting statistics in both detection modes could be shown. A solution containing rhodium (10 ng mL(-1)) and cadmium (40 ng mL(-1)) was introduced simultaneously to the GC outlet. Rhodium acts as a continuous internal standard and Cd is used for mass-bias correction (by measuring the 111Cd/113Cd ratio). The detection system in both pulse counting and analog mode was examined. The best attainable precision was established for Me2SnH2 (analog mode, 12 replicates, 1 ng, RSD 0.34%, accuracy 0.31%) whereas most other species ranged between 0.4 and 0.5% RSD if higher concentrations were used. The limitations of the pulse counting system are clearly seen, with peak heights of more than 2000 counts reaching saturation (for an integration time of 100 ms), which reduces the accuracy of isotope ratio determinations. A dozen VOM could be detected in an aged landfill gas sample; several unidentified Sn compounds were present. Although their isotope ratios are within the confidence value of the standards, it is not yet clear if the acquired precision is good enough to identify isotopic fractionation of metal(loid)s through biovolatilization processes. With the precision achieved, the combination of cryotrapping GC and ICP-TOFMS is a powerful tool for monitoring volatile multi-element species in multi-tracer experiments and isotope dilution methodology.

For the first time we are able to report the identification and quantification of several unexpected alkylated tin compounds such as dimethyldiethyltin, trimethylethyltin and propyltrimethyltin in European municipal waste deposits, by using GC-ICP-MS. Future studies will reveal whether their origin is from the degradation of butyl-, or octyltin compounds or simply products of de novo synthesis within the landfill environment.