No abstract

A Submerged Membrane Anaerobic Reactor (SMAR) is being developed for the treatment of waste water originating in Sasol's coal to fuel synthesis process. The laboratory-scale SMAR uses A4-size submerged flat panel ultrafiltration membranes to induce a 100% solids-liquid separation. Biogas gets extracted from the headspace above the anaerobic mixed liquor and reintroduced through a coarse bubble diffuser below the membranes. This induces a gas scour on the membranes that avoids biomass immobilization and membrane fouling. The substrate is a high strength (18 gCOD/l) petrochemical effluent consisting mostly of C2 to C6 short chain fatty acids with a low pH. Because of this, the pH of the reactor has to be controlled to a pH of 7.1. Organic Loading Rates of up to 25 kgCOD/m3 reactor volume/d has been observed with effluent COD normally <500 mgCOD/l and FSA <50 mgN/l with no particulates >0.45 microm at hydraulic retention times of 17 hours. 98% of the COD is converted to methane and the remainder to biomass. Mixed Liquor (MLSS) concentrations >30 gTSS/l can be maintained without deterioration of membrane fluxes, even though the Diluted Sludge Volume Index (DSVI) indicates that the sludge cannot be settled. No noteworthy deterioration in membrane performance has been observed over the 320 day operational period.

Benzene, toluene, ethylbenzene and xylene (BTEX) substrate interactions for a mesophilic (25 degrees C) and thermophilic (50 degrees C) toluene-acclimatized composted pine bark biofilter were investigated. Toluene, benzene, ethylbenzene, o-xylene, m-xylene and p-xylene removal efficiencies, both individually and in paired mixtures with toluene (1:1 ratio), were determined at a total loading rate of 18.1 g m(-3) h(-1) and retention time ranges of 0.5-3.0 min and 0.6-3.8 min for mesophilic and thermophilic biofilters, respectively. Overall, toluene degradation rates under mesophilic conditions were superior to degradation rates of individual BEX compounds. With the exception of p-xylene, higher removal efficiencies were achieved for individual BEX compounds compared to toluene under thermophilic conditions. Overall BEX compound degradation under mesophilic conditions was ranked as ethylbenzene >benzene > o-xylene > m-xylene > p-xylene. Under thermophilic conditions overall BEX compound degradation was ranked as benzene > o-xylene >ethylbenzene > m-xylene > p-xylene. With the exception of o-xylene, the presence of toluene in paired mixtures with BEX compounds resulted in enhanced removal efficiencies of BEX compounds, under both mesophilic and thermophilic conditions. A substrate interaction index was calculated to compare removal efficiencies at a retention time of 0.8 min (50 s). A reduction in toluene removal efficiencies (negative interaction) in the presence of individual BEX compounds was observed under mesophilic conditions, while enhanced toluene removal efficiency was achieved in the presence of other BEX compounds, with the exception of p-xylene under thermophilic conditions.

No abstract