SUPPLEMENTARY INFORMATION Typical measurement sequenceThe nucleation rates (J cm −3 s −1 ) are measured under neutral (J n ), galactic cosmic ray (J gcr ) or charged pion beam (J ch ) conditions. For J gcr a beam stopper blocks the pions and the chamber is irradiated by GCRs together with a small parasitic component of penetrating beam muons, whereas, for J ch , the beam stopper is opened and the pion beam is normally set to a time-averaged rate of (5 − 6) · 10 4 s −1 . Neutral nucleation rates are measured

Nucleation of aerosol particles from trace atmospheric vapours is thought to provide up to half of global cloud condensation nuclei 1 . Aerosols can cause a net cooling of climate by scattering sunlight and by leading to smaller but more numerous cloud droplets, which makes clouds brighter and extends their lifetimes 2 . Atmospheric aerosols derived from human activities are thought to have compensated for a large fraction of the warming caused by greenhouse gases 2 . However, despite its importance for climate, atmospheric nucleation is poorly understood. Recently, it has been shown that sulphuric acid and ammonia cannot explain particle formation rates observed in the lower atmosphere 3 . It is thought that amines may enhance nucleation 4-16 , but until now there has been no direct evidence for amine ternary nucleation under atmospheric conditions. Here we use the CLOUD (Cosmics Leaving OUtdoor Droplets) chamber at CERN and find that dimethylamine above three parts per trillion by volume can enhance particle formation rates more than 1,000-fold compared with ammonia, sufficient to account for the particle formation rates observed in the atmosphere. Molecular analysis of the clusters reveals that the faster nucleation is explained by a base-stabilization mechanism involving acid-amine pairs, which strongly decrease evaporation. The ion-induced contribution is generally small, reflecting the high stability of sulphuric acid-dimethylamine clusters and indicating that galactic cosmic rays exert only a small influence on their formation, except at low overall formation rates. Our experimental measurements are well reproduced by a dynamical model based on quantum chemical calculations of binding energies of molecular clusters, without any fitted parameters. These results show that, in regions of the atmosphere near amine sources, both amines and sulphur dioxide should be considered when assessing the impact of anthropogenic activities on particle formation.The primary vapour responsible for atmospheric nucleation is thought to be sulphuric acid (H 2 SO 4 ), derived from the oxidation of sulphur dioxide. However, peak daytime H 2 SO 4 concentrations in the atmospheric boundary layer are about 10 6 to 3 3 10 7 cm 23 (0.04-1.2 parts per trillion by volume (p.p.t.v.)), which results in negligible binary homogeneous nucleation of H 2 SO 4 -H 2 O (ref. 3). Additional species such as ammonia or amines 4,5 are therefore necessary to stabilize the embryonic clusters and decrease evaporation. However, ammonia cannot account for particle formation rates observed in the boundary layer 3 and, despite numerous field and laboratory studies [6][7][8][9][10][11][12][13][14][15][16] , amine ternary nucleation has not yet been observed under atmospheric conditions. Amine emissions are dominated by anthropogenic activities (mainly animal husbandry), but about 30% of emissions are thought to arise from the breakdown of organic matter in the oceans, and 20% from biomass burning and soil 8,17 . Atmospheric measurements of gasphase amines ...

Figure 1a. In experiments with similar dust surface areas, the temperature at which 50% of droplets were frozen was 250.5 K for K-feldspar, followed by 247 K for Na/Ca-feldspar, 242.5 K for quartz, and below 237.5 K for the clay minerals and calcite. These results suggest that it is the minerals of the feldspar group, in particular K-feldspar, that make mineral dust an effective immersion mode IN in the atmosphere. This data contrasts with the prevailing view 1,2 that clay minerals are the most important component of atmospheric mineral dust for ice nucleation.Droplet freezing temperatures are dependent on experimental parameters such as droplet volume and mineral surface area and are therefore of limited value 2 . In order to normalise the efficiency with which a material nucleates ice we determine the nucleation sites per unit surface area 2,11,14 (n s ; Figure 1b; see supplementary online material). This method of quantifying ice nucleation efficiency neglects the role of time dependence in nucleation, on the basis that IN particle-to-particle variability is more important than the time dependence of nucleation 2,11,14,15 . Our derived n s values for 9 -19 μm size droplets are shown in Figure 1b.This data shows that the feldspar minerals, in particular K-feldspar, are the most efficient mineral dust IN per unit surface area.In airborne dusts the abundance of clay minerals tends to be greater than the feldspars, hence it is not clear which minerals dominate ice nucleation in the atmosphere. The n s values presented in Figure 1b were combined with the average mineralogical composition of atmospheric dust to estimate the temperature-dependent IN concentration (shown in Figure 2). We have assumed that all particles are spherical in order to estimate their surface area and have made two limiting calculations, one assuming that dust particles are internally mixed (i.e. each particle contains all eight minerals) and the other assuming they are externally mixed (each particle is composed of an individual mineral). The mixing state of atmospheric dust is poorly constrained but atmospheric dust falls between these two limiting cases 16 .Despite only accounting for 3% of atmospheric dust by mass, K-feldspar dominates the number of IN above 248 K in both the internally and externally mixed cases. One potential caveat to this conclusion is that clay mineral particles may have a smaller particle size than feldspar or quartz 13 , and therefore may have a greater surface area per unit mass which would increase the concentration of clay IN. However, even if the surface area of the clays was 100 times higher (likely an overestimate 7 ), the feldspars remain the dominant ice nucleating minerals (Supplementary Figure 4). contains the most K-feldspar (20 wt%). In general, the more feldspar a sample contains the higher the freezing temperature. We hypothesise that that the feldspar component controlled the nucleation of ice in these experiments, highlighting the need to characterise sample mineralogy in such work.The mineralog...

The effect of anthropogenic aerosols on cloud droplet concentrations and radiative properties is the source of one of the largest uncertainties in the radiative forcing of climate over the industrial period. This uncertainty affects our ability to estimate how sensitive the climate is to greenhouse gas emissions. Here we perform a sensitivity analysis on a global model to quantify the uncertainty in cloud radiative forcing over the industrial period caused by uncertainties in aerosol emissions and processes. Our results show that 45 per cent of the variance of aerosol forcing since about 1750 arises from uncertainties in natural emissions of volcanic sulphur dioxide, marine dimethylsulphide, biogenic volatile organic carbon, biomass burning and sea spray. Only 34 per cent of the variance is associated with anthropogenic emissions. The results point to the importance of understanding pristine pre-industrial-like environments, with natural aerosols only, and suggest that improved measurements and evaluation of simulated aerosols in polluted present-day conditions will not necessarily result in commensurate reductions in the uncertainty of forcing estimates.

About half of present-day cloud condensation nuclei originate from atmospheric nucleation, frequently appearing as a burst of new particles near midday 1 . Atmospheric observations show that the growth rate of new particles often accelerates when the diameter of the particles is between one and ten nanometres 2,3 . In this critical size range, new particles are most likely to be lost by coagulation with pre-existing particles 4 , thereby failing to form new cloud condensation nuclei that are typically 50 to 100 nanometres across. Sulfuric acid vapour is often involved in nucleation but is too scarce to explain most subsequent growth 5,6 , leaving organic vapours as the most plausible alternative, at least in the planetary boundary layer 7-10 . Although recent studies [11][12][13] predict that low-volatility organic vapours contribute during initial growth, direct evidence has been lacking. The accelerating growth may result from increased photolytic production of condensable organic species in the afternoon 2 , and the presence of a possible Kelvin (curvature) effect, which inhibits organic vapour condensation on the smallest particles (the nano-Köhler theory) 2,14 , has so far remained ambiguous. Here we present experiments performed in a large chamber under atmospheric conditions that investigate the role of organic vapours in the initial growth of nucleated organic particles in the absence of inorganic acids and bases such as sulfuric acid or ammonia and amines, respectively. Using data from the same set of experiments, it has been shown 15 that organic vapours alone can drive nucleation. We focus on the growth of nucleated particles and find that the organic vapours that drive initial growth have extremely low volatilities (saturation concentration less than 10 −4.5 micrograms per cubic metre). As the particles increase in size and the Kelvin barrier falls, subsequent growth is primarily due to more abundant organic vapours of slightly higher volatility (saturation concentrations of 10 −4.5 to 10 −0.5 micrograms per cubic metre). We present a particle growth model that quantitatively reproduces our measurements. Furthermore, we implement a parameterization of the first steps of growth in a global aerosol model and find that concentrations of atmospheric cloud concentration nuclei can change substantially in response, that is, by up to 50 per cent in comparison with previously assumed growth rate parameterizations.Two measurement campaigns at the CERN CLOUD (Cosmics Leaving OUtdoor Droplets) chamber (Methods) focused on aerosol growth with different levels of sulfuric acid and α-pinene oxidation products. With the chamber at 278 K and 38% relative humidity, tropospheric concentrations of α-pinene, ozone (O 3 ) and SO 2 were introduced (see Extended Data Table 1). Using various instruments (Methods and Extended Data Fig. 1) we measured the behaviour of freshly nucleated particles of 1-2 nm diameter and their subsequent growth up to 80 nm. Two chemical ionization mass spectrometers (Methods) using nitrate as th...