a Field-Effect Transistor sensors (FET-sensors) have been receiving increasing attention for biomolecular sensing over the last two decades due to their potential for ultra-high sensitivity sensing, label-free operation, cost reduction and miniaturisation. Whilst the commercial application of FET-sensors in pH sensing has been realised, their commercial application in biomolecular sensing (termed BioFETs) is hindered by poor understanding of how to optimise device design for highly reproducible operation and high sensitivity. In part, these problems stem from the highly interdisciplinary nature of the problems encountered in this field, in which knowledge of biomolecular-binding kinetics, surface chemistry, electrical double layer physics and electrical engineering is required. In this work, a quantitative analysis and critical review has been performed comparing literature FET-sensor data for pH-sensing with data for sensing of biomolecular streptavidin binding to surface-bound biotin systems. The aim is to provide the first systematic, quantitative comparison of BioFET results for a single biomolecular analyte, specifically streptavidin, which is the most commonly used model protein in biosensing experiments, and often used as an initial proofof-concept for new biosensor designs. This novel quantitative and comparative analysis of the surface potential behaviour of a range of devices demonstrated a strong contrast between the trends observed in pH-sensing and those in biomolecule-sensing. Potential explanations are discussed in detail and surfacechemistry optimisation is shown to be a vital component in sensitivity-enhancement. Factors which can influence the response, yet which have not always been fully appreciated, are explored and practical suggestions are provided on how to improve experimental design.

Optical solar reflector smart radiators are able to control the temperature of spacecraft. This work demonstrates a novel smart optical solar reflector using a patterned thermo-chromic VO2 plasmonic meta-surface design. The VO2 meta-surface combines the temperature induced phase transition of VO2 with plasmonic resonances resulting in a significant enhancement of the infrared absorption. The enhanced absorption obtained at a reduced VO2 coverage results in superior emittance tunability Δε and lower solar absorptance α compared to a corresponding thin-film reflector. An emittance tunability of 0.48 is obtained for the meta-reflector design, representing a 30% improvement compared to the unstructured film. Meta-surface based smart optical solar reflectors offer a new route toward energyefficient and cost-effective passive thermal control systems of spacecraft and other surfaces.

Polysilicon nanowire biosensors have been fabricated using a top-down process and were used to determine the binding constant of two inflammatory biomarkers. A very low cost nanofabrication process was developed, based on simple and mature photolithography, thin film technology, and plasma etching, enabling an easy route to mass manufacture. Antibody-functionalized nanowire sensors were used to detect the proteins interleukin-8 (IL-8) and tumor necrosis factor-alpha (TNF-α) over a wide range of concentrations, demonstrating excellent sensitivity and selectivity, exemplified by a detection sensitivity of 10 fM in the presence of a 100 000-fold excess of a nontarget protein. Nanowire titration curves gave antibody−antigen dissociation constants in good agreement with low-salt enzyme-linked immunosorbent assays (ELISAs). This fabrication process produces high-quality nanowires that are suitable for low-cost mass production, providing a realistic route to the realization of disposable nanoelectronic point-of-care (PoC) devices.

Optical Solar Reflectors are devices that combine high reflection for visible wavelengths with a strong emissivity in the infrared. Compared to the conventional rigid quartz tiles used on spacecraft since the 1960s, thin-film solutions can offer a significant advantage in weight, assembly and launch costs. Here, we present a metasurface based approach using an Al-doped * To whom correspondence should be addressed † Electronics ‡ Physics ¶ CREO § NILT ZnO (AZO) transparent conducting oxide as infrared plasmonic material. The AZO is patterned into a metasurface to achieve broad plasmonic resonances with enhanced absorption of electromagnetic radiation in the thermal infrared. In the visible range, the transparent conducting oxide provides low losses for solar radiation, while intrinsic absorption losses in the ultraviolet range are effectively suppressed using a multilayer reflecting coating. The addition of high-emissivity layers to the stack eventually results in comparable emissivity values to the thin plasmonic device, thus defining a window of opportunity for plasmonic absorption as a design strategy for ultrathin devices. The optimized experimental structure achieves solar absorptance (α) of 0.16 and thermal emissivity (ε) of 0.79. Our first prototype demonstrator paves the way for further improvement and large-area fabrication of metasurface solar reflectors, and ultimately their application in space missions.

No abstract