No abstract

An atomic force microscope colloidal probe technique has been employed to probe normal and friction forces between silica surfaces coated with adsorbed layers of a diblock copolymer of the composition poly(N-isopropylacrylamide) 48 -block-poly(3-acrylamidopropyl)trimethylammonium chloride) 20 , abbreviated PNIPAAM 48 -b-PAMPTMA(+) 20 . The interactions between the PNIPAAM 48 -b-PAMPTMA(+) 20 -coated surfaces across a 0.1 mM NaCl (pH 6) solution at 25 C are purely repulsive, due to a combination of steric and electrostatic double-layer forces. However, when the temperature is increased to 35 C, and subsequently to 45 C, an attractive force develops at short separations due to the unfavourable PNIPAAM-water interaction at these temperatures. The temperature-dependent polymer-water interaction has implications for the friction force between the layers. At 25 C a frictional force that increases linearly with increasing load is observed once the surfaces are brought into close contact. At higher temperatures significantly higher friction forces appear as a consequence of attractive segment-segment interactions. Further, a clearly expressed hysteresis between friction forces encountered on loading and unloading is detected. Our results demonstrate that both normal and friction forces between surfaces can be controlled by temperature changes when temperatureresponsive polymers are employed, and friction forces can be adjusted as required from low to high.

A combination of turbidity, light scattering, and steady shear viscosity experiments has revealed that aqueous solutions of an amphiphilic diblock copolymer or a negatively charged triblock copolymer, both containing poly(N-isopropylacrylamide), can undergo a temperature-induced transition from loose intermicellar clusters to collapsed core-shell nanostructures. Turbidity, light scattering, and viscosity results of these short-chain copolymers disclose transition peaks at intermediate temperatures. At high temperatures, the compact core-shell particles from the diblock copolymer aggregate, whereas no renewed interpolymer association is observed for the triblock copolymer or for the solution of the diblock copolymer with added sodium dodecyl sulfate because the electrostatic repulsive interactions suppress the tendency of forming interpolymer clusters. The temperature-induced building up of intermicellar structures and the formation of large aggregates at high temperature in the solution of the diblock copolymer is significantly reduced under the influence of high shear rates.

The influence of shear flow on aggregation and disaggregation in aqueous solutions of the thermoresponsive methoxy-poly(ethylene glycol)-block-poly(N-isopropylacrylamide) (MPEG53-b-PNIPAAM113) copolymer that exhibits a lower critical solution temperature was investigated with the aid of turbidity, shear viscosity, and rheo small angle light scattering (rheo-SALS) methods. The turbidity results at quiescent conditions revealed a novel transition peak in the turbidity curve at intermediate temperatures, which reflects the delicate interplay between temperature-induced aggregation and shrinking of the species. A similar anomalous transition peak (located at the same temperature) was observed in the steady shear viscosity measurements at intermediate temperatures, and the amplitude of the peak was reduced with increasing shear rate as a consequence of breakup of interaggregate chains. At low temperatures (low sticking probability), enhanced shear rate generated interpolymer aggregates; whereas in the high-temperature domain (high sticking probability) association structures were broken up as the shear rate was increased. The rheo-SALS experiments disclosed growth of aggregates at low temperatures and destruction of association complexes at high temperatures. An increase of the cloud point temperature with rising shear rate is reported, which is interpreted as being a disruption of clusters under the influence of shear stresses.

Therapeutic nanoparticles (NPs) have great potential to deliver drugs against human diseases. Encapsulation of drugs in NPs protects them from being metabolized, while they are delivered specifically to a target site, thereby reducing toxicity and other side-effects. However, non-specific tissue accumulation of NPs, for example in macrophages, especially in the spleen and liver is a general problem with many NPs being developed for cancer therapy. To address the problem of non-specific tissue accumulation of NPs we describe the development of the zebrafish embryo as a transparent vertebrate system for characterization of NPs against cancer. We show that injection of human cancer cells results in tumor-like structures, and that subsequently injected fluorescent NPs, either made of polystyrene or liposomes can be imaged in real-time. NP biodistribution and general in vivo properties can be easily monitored in embryos having selective fluorescent labeling of specific tissues. We demonstrate in vitro, by using optical tweezer micromanipulation, microscopy and flow cytometry that polyethylene glycol (PEG) coating of NPs decreases the level of adhesion of NPs to macrophages, and also to cancer cells. In vivo in zebrafish embryos, PEG coating resulted in longer NP circulation times, decreased macrophage uptake, and reduced adhesion to the endothelium. Importantly, liposomes were observed to accumulate passively and selectively in tumor-like structures comprised of human cancer cells. These results show that zebrafish embryo is a powerful system for microscopy-based screening of NPs on the route to preclinical testing.