Exchange of initial, predominantly stearate ligands for pyridine in the first step and butylamine (BA) or 11-mercaptoundecanoic acid (MUA) in the second one was studied for alloyed quaternary Cu-In-Zn-S nanocrystals. The NMR results enabled us to demonstrate, for the first time, direct binding of the pyridine labile ligand to the nanocrystal surface as evidenced by paramagnetic shifts of the three signals attributed to its protons to 7.58, 7.95 and 8.75 ppm. XPS investigations indicated, in turn, a significant change in the composition of the nanocrystal surface upon the exchange of initial ligands for pyridine, which being enriched in indium in the 'as prepared' form became enriched in zinc after pyridine binding. This finding indicated that the first step of ligand exchange had to involve the removal of the surface layer enriched in indium with simultaneous exposure of a new, zinc-enriched layer. In the second ligand exchange step (replacement of pyridine with BA or MUA) the changes in the nanocrystal surface compositions were much less significant. The presence of zinc in the nanocrystal surface layer turned out necessary for effective binding of pyridine as shown by a comparative study of ligand exchange in Cu-In-Zn-S, Ag-In-Zn-S and CuInS2, carried out by complementary XPS and NMR investigations.

Ternary Ag-In-S or quaternary Ag-In-Zn-S nanocrystals were prepared from simple precursors (silver nitrate, indium(iii) chloride, zinc stearate in a mixture of DDT and ODE) by injecting a solution of elemental sulfur into OLA. Ternary nanocrystals were modified by depositing either a ZnS or a CdS shell, yielding type I and type II core/shell systems exhibiting photoluminescence QY in the range of 12-16%. Careful optimization of the reaction conditions allowed alloyed quaternary Ag-In-Zn-S nanocrystals exhibiting tunable photoluminescence in the spectral range of 520-720 nm with a QY of 48% and 59% for green and red radiations, respectively, to be obtained. H NMR analysis of the nanocrystal organic shell, after dissolution of its inorganic core, indicated that surfacial sulfur atoms were covalently bonded to aliphatic chains whereas surfacial cations were coordinated by amines and carboxylate anions. No thiol-type ligands were detected. Transfer of the prepared nanocrystals to water could be achieved in one step by exchanging the initial ligands for 11-mercaptoundecanoic ones resulting in a QY value of 31%. A new Ag-In-Zn-S nanocrystal preparation method was elaborated in which indium and zinc salts of fatty acids were used as cation precursors and DDT was replaced by thioacetamide. This original DDT-free method enabled similar tuning of the photoluminescence properties of the nanocrystals as in the previous method; however the measured photoluminescence QYs were three times lower. Hence, further optimization of the new method is required.

Indanthrone, an old, insoluble dye can be converted into a solution processable, self-assembling and electroluminescent organic semiconductor, namely tetraoctyloxydinaptho[2,3-a:2 0 ,3 0 -h]phenazine (P-C8), in a simple one-pot process consisting of the reduction of the carbonyl group by sodium dithionite followed by the substitution with solubility inducing groups under phase transfer catalysis conditions.

The presented research is focused on the synthesis of alloyed Ag−In−Zn−S colloidal nanocrystals from a mixture of simple metal precursors such as AgNO 3 , InCl 3 , zinc stearate combined with 1-dodecanethiol (DDT), 1-octadecene (ODE), and sulfur dissolved in oleylamine (OLA). In particular, the focus is on the effect of the solvent (ODE vs 1,2dichlorobenzene (DCB)) and the type of sulfur precursor (S/ OLA vs S/n-octylamine (OCA)) on the metal precursors reactivates and on the chemical composition, crystal structure, and luminescent properties of the resulting nanocrystals. The replacement of ODE by DCB as a solvent lowers the reactivity of metal precursors and results in a 3-fold decrease of the photoluminescence quantum yields (Q.Y.) values (from 67% to 21%). This negative effect can be fully compensated by the use of S/OCA as a source of sulfur instead of S/OLA (Q.Y. increases from 21% to 64%). NMR studies of the isolated organic phase indicate that the S/OLA precursor generates two types of ligands being products of (Z)-1-amino-9-octadecene (OLA) hydrogenation. These are "surface bound" 1-aminooctadecane (C 18 H 37 NH 2 ) and crystal bound, i.e., alkyl chain covalently bound to the nanocrystal surface via surfacial sulfur (C 18 H 37 -NH-S crystal). Highly luminescent Ag−In−Zn−S nanocrystals exhibit a cation-enriched (predominantly indium) surface and are stabilized by a 1-aminooctadecane ligand, which shows more flexibility than OLA. These investigations were completed by hydrophilization of nanocrystals obtained via exchange of the primary ligands for 11-mercaptoundecanoic acid, (MUA) with only a 2-fold decrease of photoluminescence Q.Y. in the most successful case (from 67% to 31%). Finally, through ligand exchange, an electroactive inorganic/organic hybrid was obtained, namely, Ag−In−Zn−S/7-octyloxyphenazine-2-thiol, in which its organic part fully retained its electrochemical activity.