The effect of the inclusion of flufenamic acid in poly(lactide-co-glycolide) nanoparticles on the transport of flufenamic acid into excised human skin was investigated. Penetration and permeation data were acquired using two different in vitro test systems: the Saarbrücken penetration model, where the skin acts as its own receptor medium, and the Franz diffusion cell, where the receptor medium is a buffer solution. For the stratum corneum, no differences were found between nanoencapsulated and free drug. Drug accumulation in the deeper skin layers and drug transport across human epidermis were slightly delayed for the nanoencapsulated drug compared to the free drug after shorter incubation times (<12 h). In contrast, after longer incubation times (>12 h), the nanoencapsulated drug showed a statistically significantly enhanced transport and accumulation (p < 0.05). Additionally, nanoencapsulated flufenamic acid was visualized by multiphoton fluorescence microscopy. Particles were found homogeneously distributed on the skin surface and within the dermatoglyphs, but no nanoparticles were detected within or between the corneocytes.

No abstract

No abstract

No abstract

The investigation of drug penetration into the stratum corneum (SC) by tape-stripping requires an accurate measure of the amount of SC on each tape-strip in order to determine the depth inside the SC. This study applies infrared densitometry (IR-D) to in vitro tape-stripping using the novel Squame Scan® 850A. The device had recently been shown to provide accurate measurements of the SC depth for tape-stripping in vivo. Furthermore, the suitability of IR-D for determining the endpoint of tape-stripping, i.e. complete SC removal, was tested. The SC depth was computed from the IR-D data of sequential tape-strips and compared to the results of a protein assay as gold standard. IR-D provided accurate depth results both for freshly excised skin and for skin stored frozen for up to 3 months. In addition, the lower limit of quantification of IR-D indicates the complete removal of the SC (less than 5% of the total SC remaining) and can be used for adjusting the number of tapes applied in situ. Therefore, IR-D is an accurate, fast and non-destructive method for SC depth determination.