Mechanical stress caused to transfected Chinese hamster ovary (CHO) suspension cells by reusable and single‐use magnetically levitated, bearingless centrifugal pumps was investigated. Cell death rates were determined for different pump speeds and compared with data from a peristaltic and a 4‐piston diaphragm pump. Furthermore, the fluid distribution inside the PuraLev® 200 pump was modeled using computational fluid dynamics. The results reveal considerably lower mechanical stress to CHO cells caused by the magnetically levitated bearingless centrifugal pumps than by the peristaltic and diaphragm pump.

An in 2016 published DECHEMA guideline concerning process engineering characterization and a new Escherichia coli model process were utilized for the qualification of two geometrically similar stirred stainless steel bioreactors (30 L and 100 L working volume). The achieved results demonstrate that performing an additional biological model process is a valuable complement to the process engineering characterization. Optical densities of 27 (100 L) and 39 (30 L) were reached in the batch cultivation process.

No abstract

The power input in stirred bioreactors is an important scaling-up parameter and can be measured through the torque that acts on the impeller shaft during rotation. However, the experimental determination of the power input in small-scale vessels is still challenging due to relatively high friction losses inside typically used bushings, bearings and/or shaft seals and the accuracy of commercially available torque meters. Thus, only limited data for small-scale bioreactors, in particular single-use systems, is available in the literature, making comparisons among different single-use systems and their conventional counterparts difficult.This manuscript provides a protocol on how to measure power inputs in benchtop scale bioreactors over a wide range of turbulence conditions, which can be described by the dimensionless Reynolds number (Re). The aforementioned friction losses are effectively reduced by the use of an air bearing. The procedure on how to set up, conduct and evaluate a torque-based power input measurement, with special focus on cell culture typical agitation conditions with low to moderate turbulence (100 < Re < 2·104), is described in detail. The power input of several multi-use and single-use bioreactors is provided by the dimensionless power number (also called Newton number, P0), which is determined to be in the range of P0 ≈ 0.3 and P0 ≈ 4.5 for the maximum Reynolds numbers in the different bioreactors.

Pumps are mainly used when transferring sterile culture broths in biopharmaceutical and biotechnological production processes. However, during the pumping process shear forces occur which can lead to qualitative and/or quantitative product loss. To calculate the mechanical stress with limited experimental expense, an oil-water emulsion system was used, whose suitability was demonstrated for drop size detections in bioreactors 1 . As drop breakup of the oil-water emulsion system is a function of mechanical stress, drop sizes need to be counted over the experimental time of shear stress investigations. In previous studies, the inline endoscopy has been shown to be an accurate and reliable measurement technique for drop size detections in liquid/liquid dispersions. The aim of this protocol is to show the suitability of the inline endoscopy technique for drop size measurements in pumping processes. In order to express the drop size, the Sauter mean diameter d 32 was used as the representative diameter of drops in the oil-water emulsion. The results showed low variation in the Sauter mean diameters, which were quantified by standard deviations of below 15%, indicating the reliability of the measurement technique. Video LinkThe video component of this article can be found at